ML Accessories
Instruction Manual for Knightsbridge models including: GUSPIKER, GUSPIKES, GUSPIKER 230V IP65 GU10 Square Spike Light, GUSPIKER, 230V IP65 GU10 Square Spike Light, Square Spike Light, Spike Light, Light
Knightsbridge 230V IP65 GU10 Square Spike Light - Black - Electrical 4 Less
File Info : application/pdf, 6 Pages, 82.57KB
DocumentDocumentINSTALLATION & MAINTENANCE MANUAL GUSPIKER / GUSPIKES GENERAL INSTRUCTIONS These instructions should be read carefully and retained by the end-user after installation for future reference and maintenance. These instructions should be used to aid the installation of the following products: GUSPIKER / GUSPIKES SAFETY · This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician · Please isolate mains prior to installation or maintenance · Check the total load on the circuit (including when this product is fitted) does not exceed the rating of the circuit cable, fuse or circuit breaker · Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for installation · This product is Class I and must be earthed · This product is IP65 rated INSTALLATION Provide power to the required point of installation (refer to BS7671 for correct cabling methods). Suitable IP rated junction boxes should be used where required · The power source connections should be local and accessible via a suitable IP rated enclosure · Choose a position for the luminaire ensuring the ground is suitable to firmly hold the spike and luminaire in position. Check the ground is not liable to flooding and the spike does not infringe with any underground pipes or cables (see Fig. 1) · Fig. 1 · · The body of the product should not rest directly on the ground · · The preinstalled cable supplied is for above-ground use only. Cables that are to be routed within walls or below ground must be protected by means of suitable conduit or trunking (see Fig. 2) Fig. 2 · · For wall mounting, using the bracket as a template, mark the location for, and drill the fixing holes ensuring not to infringe with any gas/water pipes or electrical cables (see Fig. 3). Fix the bracket to the surface using suitable fixings (not included) · Fig. 3 · · · · Connect the luminaire to the mains supply ensuring the correct polarity is observed: Live (brown), Earth (green/yellow), Neutral (blue) · · Insert a suitable GU10 lamp (max. 35W) · · Switch on and check for correct operation WARNING This product is not suitable for installation in or near a coastal or marine environment. GENERAL Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not use aggressive cleaning products or solvents which may damage the product. Do not use any source of high-pressure washers to maintain or clean this product. This product is dimmable dependant on lamp type. This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where facilities exist. WARRANTY This product has a warranty of 2 years from the date of purchase. Failure to install this product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve the right to alter product specification without prior notice. INTERNATIONAL CONTACT DETAILS 130 ML Accessories Limited LU5 4LT www.mlaccessories.co.uk AKDEC21_V1