Auto-empty Robot Vacuum Cleaner Instruction Manual

Models: SL62, SDL62

Before using this product, please carefully read this manual and keep it properly.

About Robot

Buttons:

Recharge/Pause: Press to recharge/pause. [recharge-pause-button]
Power/Clean/Pause: Press to start cleaning/pause. Press and hold for 3 seconds to power on/off. [power-button]

Indicators:

Wi-Fi status light: Off: Wi-Fi not networked; Flash: Being networked; Normally on: Wi-Fi networked. ?
Reset: System reset button. Use a needle to press this button to reset the device. [reset-button]

Status Light	Cleaning	Recharging	Charging	Low power	Fullycharged	Alarming	Standby
light	Blue light on	Blue light on	Blue light flickering	Red light flickering	Blue light on	Red light flickering	Off

Robot Exterior Components:

Robot Underside Components:

Dock Components:

Dust bin assembly Components:

Before starting the vacuum cleaner, clean up wires and sundries scattered on the ground, and remove easy-to-fall, fragile, valuable and potentially dangerous items. Avoid being entangled, stuck, dragged or knocked down by the main unit; otherwise, personal injury or property damage may be caused. ❌
Do not use the robot to clean liquid. ❌
When used in a suspended circumstance, it shall be protected by rails to avoid accidental falling or pushing other articles from falling; otherwise, personal or property damage may be caused. ✔️

Remove the protection material from both sides of the robot.
Install side brushes: Align the left brush with the motor on the bottom, then press down and hear the "click" sound, which means the installation is in place.
Take out and place the Auto-empty dock on a flat floor against the wall and tidy up the redundant wires.
Clean up the area around the dock and connect the power supply that meets the requirement of electricity consumption. Ensure space more than 0.5m from the left and right to the charging base and 1.5m in front of the charging base.
Do not move the charging base at will; avoid direct sunlight on the charging base. ❌ Note: The sunlight may interfere the recharging signal, which may cause the robot vacuum cleaner to fail to return to the charging base.
Power on and charge: Press and hold the [power-button] to power on. When the indicator light is normally on, put the main unit against the charging base for charging. When you hear the voice of "Start charging", it means that the robot is being charged successfully. Note: If the battery is at low level, the robot cannot be powered on. Please put the robot vacuum cleaner on the charging base and the device will be powered on automatically.

Open the water injection cover, add appropriate amount of water and then cover tightly. Please do not add any detergent.
Put the water tank back into the robot.
Install the mop on the mop support.
Install the mop support.

Search "Smart Life" in the mobile app store and download the APP.
Register and log into the APP.
Click "Add a device" or "+" in the top right corner.
Select "Small household appliance" -> "robot vacuum cleaner (Wi-Fi)".
Select 2.4 GHz Wi-Fi Network and enter password. Note: If your Wi-Fi is 5GHz, please set it to be 2.4GHz.

Turn on the cleaner robot first, press and hold the [power-button] and [recharge-pause-button] buttons together for 3 seconds at the same time, then hear the prompt voice "connecting network", and the Wi-Fi indicator flashes quickly, indicating that it has entered the network distribution mode.
Click [add-device-icon] to select "Add Device".
Select the corresponding Wi-Fi and connect, and confirm that the Wi-Fi indicator light of the cleaner robot flashes quickly.
The name of the cleaner robot appears on the connection interface, click to select and start automatic network configuration.
Wait for the APP to connect with the cleaner robot, and enter the operation interface after the connection is successful.
After entering the APP operation interface, you can draw a map and operate the cleaner robot.