KENDO+ DYNAMO Instruction Manual

Front Light Installation

[Step 1]: Mount the front light and connect wiring.

Attach the front bicycle light to the bicycle's front fork. Route the wires from the light downwards. The diagram shows the light being secured to the fork with a bracket. A wire is shown connecting from the light towards the wheel hub.

[Step 2]: Connect wires to the dynamo hub.

Connect the wires to the bicycle's dynamo hub. The diagram illustrates connecting the wires to the positive [positive terminal] and negative [negative terminal] contacts on the dynamo hub. This setup requires a 6V AC power source generated by the dynamo.

Light Performance

The KENDO+ DYNAMO light is designed to provide optimal visibility. The diagram indicates that the light achieves 100% brightness and shows the projected beam pattern onto the road surface, ensuring adequate illumination.

Operation

[Step 3]: Control the light.

To operate the light, press the button on the light unit. A single press (1x ON) turns the light on. Two consecutive presses (2x OFF) turn the light off. The diagram shows a finger pressing the button on the front light.

Rear Light Installation

[Step 4]: Mount the rear light (Model CC01).

Attach the rear bicycle light, identified as model CC01, to the bicycle. The diagram shows the rear light being mounted, likely to the seat post or a rear rack. Wires are shown connecting from the rear light to the dynamo hub, similar to the front light connection. The connection indicates positive [positive terminal] and negative [negative terminal] terminals.