Cudy POE10 Gigabit PoE+ Extender: User Manual & Specifications
5 Maximum Distances for Power Sources
Multiple PoE Extenders can be connected every 100 meters to obtain greater distances. The actual figures depend on operating conditions. The range is over 24AWG or heavier Cat-5e or Cat-6 cable except where specified.
Examples for medium power PoE Devices (that are PoE Class 2, or require under 6 watts)
| PoE Source | Maximum Distances |
|---|---|
| PoE switch (802.3af, Output voltages 50V) | 300M |
| 15W mid-span (802.3af, Output voltages 50V) | 300M |
| PoE+ switch (802.3at, Output voltages 50V) | 400M |
| 30W mid-span (802.3at, Output voltages 50V) | 400M |
Examples for full power PoE Devices (that are PoE Class 0 or 3, or require under 12 watts)
| PoE Source | Maximum Distances |
|---|---|
| PoE switch (802.3af, Output voltages 50V) | 200M |
| 15W mid-span (802.3af, Output voltages 50V) | 200M |
| PoE+ switch (802.3at, Output voltages 50V) | 300M |
| 30W mid-span (802.3at, Output voltages 50V) | 300M |
Examples for PoE+ Devices (that are PoE Class 4 that under 22 watts, or 802.3at compliant)
| PoE Source | Maximum Distances |
|---|---|
| PoE switch (802.3af, Output voltages 50V) | Not applicable |
| 15W mid-span (802.3af, Output voltages 50V) | Not applicable |
| PoE+ switch (802.3at, Output voltages 50V) | 200M |
| 30W mid-span (802.3at, Output voltages 50V) | 200M |
EU Declaration of Conformity
Cudy hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU. The original EU declaration of conformity may be found at http://www.cudy.com/.
Support and Warranty
For support and warranty, please visit: http://www.cudy.com/. Specifications are subject to change without notice. Cudy is a registered trademark of Shenzhen Cudy Technologies Co., Ltd. Other brands and product names are trademarks or registered trademarks of their respective holders.
Copyright © Shenzhen Cudy Technology Co., Ltd. All rights reserved.
EU Address: Otto esser 2c, 65451 Kelsterbach, Germany
Compliance Marks: FC CE EAC [info] RoHS
Model: POE10
1 Hardware Connection
Diagram Description: A PoE+ Switch connects to a PoE Extender via a network cable up to 100 meters. The PoE Extender then connects to a camera via another network cable, also up to 100 meters. This setup can be extended.
Extended Distance Setup: A PoE+ Switch can be connected to up to three PoE Extenders in series, each separated by up to 100 meters of cable, to extend the total distance to a camera up to 400 meters.
2 Description
Cudy Gigabit PoE+ Extender helps install PDs (such as IP Security Cameras, wireless access points) at greater distances than 100 meters. By connecting a PoE+ Extender for every extra 100 meters of cable, both Ethernet and PoE can be extended to up to a total distance of 200 meters. It does not require any additional power supply; the connected PDs are fed by a single PoE switch or mid-span, which simplifies installation.
3 Features
- IEEE802.3at / IEEE802.3af Compliant
- 10/100/1000Mbps Ethernet Ports
- Wall-Mount design for any application scenario
- Easy plug-and-play installation
- No additional power supply is required
- One PoE extender extends additional 100 meters for PoE network
- Support up to 3 PoE Extenders for a total extension of 400 meters
4 Specifications
| Specification | Details |
|---|---|
| Model | POE10 |
| No. of channels | 1 (PoE IN) into 1 (PoE OUT) |
| Pass Through Data Rates | 10/100/1000 Mbps half/full duplex |
| Power over Ethernet input | Pin Assignment and Polarity: Both 1/2(-), 3/6(+) and 4/5(+), 7/8(-) |
| Power over Ethernet Output | Pin Assignment and Polarity: 1/2 (+), 3/6 (-) Output Power: up to 22W |
| Indicators | Power indicator: PoE enabled; Network indicator: Link/Act |
| Connectors | Shielded RJ-45, EIA568A and 568B |
| Network cables | Shielded category 5 (or higher) |
| Mounting | Wall or shelf |
| Environment | Indoor or Outdoor |
| Operating Ambient Temperature | -10 to 45°C |
| Operating Humidity | Maximum 90%, Non-condensing |
| Storage Temperature | -20 to 60°C |
| Storage Humidity | Maximum 95%, Non-condensing |
| Regulatory Compliance | IEEE 802.3af (PoE), IEEE 802.3at (PoE+) |
| Dimensions | 145mm x 60mm x 40mm |








