RIGID Installation Instructions

Amber White SAE Fog Lights

Products Include:

(2) Amber White Lights (360 or D-Series)
Mounting hardware

Important Information

Thank you for purchasing RIGID INDUSTRIES' products for your vehicle. Please read through all of these instructions and tips before proceeding with the installation. RIGID Industries strives to provide a simple installation process for all applications; however, a professional installation is always recommended.

Always disconnect any power sources connected to your vehicle before servicing fuses or electrical systems.

Wiring Leads

RED WIRE: WHITE PROJECTING TRIGGER

BLACK WIRE: GROUND

WHITE WIRE: AMBER PROJECTING TRIGGER

360-Series Mounting Instructions & Diagram

The following table details the components and steps for mounting the 360-Series lights:

Part	Description	Action
A	M8x25mm Carriage Bolt	Place through bracket
B	M8 Flat Washer	Place on carriage bolt
C	M8 Lock Washer	Place on carriage bolt
D	M8 Nut	Tighten light to bracket
E	M6 Ny Lock Nut	Place in Heatsink
F	Mounting Bushing	Slide into Heatsink
G	6-32x.375" Socket Head	Tighten mount bushing to Heatsink
H	M6 Flat Washer	Place on item I prior to install
I	M6x22mm Socket Head	Tighten the bracket to the light (Torque 32in-lbs)

Diagram Description: The diagram visually represents the assembly of the 360-Series light with its mounting hardware, showing the placement of parts A through I.

D-Series Mounting Instructions & Diagram

The following table details the components and steps for mounting the D-Series lights:

Part	Description	Action
A	LED Light (Housing)	Place through bracket
B	M6 Allen Socket Head (2)	Place through light and bracket
C	M6 Nyloc Nut (2)	Tighten to M6 Allen bolt
*D	Mounting Bracket	Place into light housing
E	5/16"- 18 Carriage Bolt	Place through bracket (bottom)
F	5/16" Carriage Washer	Place on carriage bolt (first)
G	5/16" Carriage Lock Washer	Place on carriage bolt (second)
H	5/16"- 18 Carriage Nut	Tighten to 5/16"-18 carriage bolt

*Note: The mounting bracket can be reversed for additional mounting configurations.

Diagram Description: The diagram illustrates the assembly of the D-Series LED light, showing the connection of parts A through H, including the mounting bracket.

Wiring and Completion

Wire your lights according to the instructions included with the light. Take care to avoid any heat sources and sharp or abrasive surfaces.

Your installation is now complete. Welcome to the Rigid Nation!

Warranty Information

For warranty information, visit www.rigidindustries.com/about/warranty.

Address: 779 N Colorado St, Gilbert, AZ 85233

Phone: 855-760-5337

Website: www.rigidindustries.com

RIGID, 360-Series, D-Series and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.

Document Number: 11-14014-A