BAUKNECHT B2I HD526 A Fully Integrated Dishwasher User Guide

User Guide for BAUKNECHT models including: B2I HD526 A Fully Integrated Dishwasher, B2I HD526, A Fully Integrated Dishwasher, Fully Integrated Dishwasher, Integrated Dishwasher, Dishwasher

Bedienungsanleitung (PDF)

BAUKNECHT vollintegrierbarer Geschirrspüler, B2I HD526 A, 14 Maßgedecke

File Info : application/pdf, 12 Pages, 19.84MB

Guide-d-utilisation-quotidienne

Quick Guide

THANK YOU FOR BUYING A BAUKNECHT PRODUCT. In order to receive a more complete assistance, please register your appliance on: www.bauknecht.eu/register

PLEASE SCAN THE QR CODE ON YOUR APPLIANCE IN ORDER TO HAVE MORE DETAILED INFORMATION

Before using the appliance carefully read Safety Instructions guide.

CONTROL PANEL

1. ON-OFF/Reset button with indicator light 2. Program selection button 3. Salt refill indicator light 4. Rinse Aid refill indicator light 5. Program number and delay time indicator 6. Tablet indicator light

7. Display 8. Half Load indicator lights 9. Half Load button 10. Delay button 11. START/Pause button with
indicator light / Tablet (Tab)

2 3 4 5 67 8 9

10 11

FIRST TIME USE

FILLING THE SALT RESERVOIR The use of salt prevents the formation of LIMESCALE on the dishes and on the machine's functional components. · It is mandatory that the salt reservoir never be empty. · It is important to set the water hardness. The salt reservoir is located in the lower part of the dishwasher and must be filled when the SALT REFILL indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the reservoir cap (anticlockwise).
2. Position the funnel (see figure) and fill the salt reservoir right up to its edge (approximately 1 kg); it is not unusual for a little water to leak out.
3. Only the first time you do this: fill the salt reservoir with water.
4. Remove the funnel and wipe any salt residue away from the opening. Make sure the cap is screwed on tightly, so that no detergent can get into the container during the wash program (this could damage the water softener beyond repair). Whenever you need to add salt, it is mandatory to complete the procedure before the beginning of the washing cycle to avoid corrosion.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid

dispenser A should be filled when the RINSE AID

REFILL indicator light in the control panel is lit.

NEVER pour the rinse aid directly into the

appliance tub.

FILLING THE DETERGENT DISPENSER To open the detergent dispenser use the opening device C. Introduce the detergent into the dry dispenser D only. Place the amount of detergent for pre-washing directly inside the tub. If all-in-one detergents are used, we recommend using the TABLET button, because it adjusts the program so that the best washing and drying results are always achieved. Usage of detergent not designed for dishwashers may cause malfunction or damage to the appliance.
WATER SOFTENING SYSTEM Water softener automatically reduces water hardness, consequently preventing scale buildup on heater, contributing also to better cleaning efficiency. This system regenerates itself with salt, therefore it is required to refill salt container when empty. Frequency of regeneration depends on water hardness level setting - regeneration takes place once per 6 Eco cycles with water hardness level set to 3. Regeneration process starts in final rinse and finishes in drying phase, before cycle ends. · Single regeneration consumes: ~3.5L of water; · Takes up to 5 additional minutes for the cycle; · Consumes below 0.005kWh of energy.

PROGRAMS TABLE

Program

Programs description

Eco 50°- Eco program is suitable to clean normally soiled tableware.

that for this use. it is the most efficient program in terms of its combined energy and water consumption. and that it is used to

assess compliance with the EU Ecodesign legislation.

Intensive 65° - Program recommended for heavily soiled crockery.

especially suitable for pans and saucepans (not to be used for

delicate items).

Mixed 55° - Mixed soil. For normally soiled dishes with dried food residues.

Drying phase

Available options *)

Duration of wash program (h:min)**)

Water

Energy

consumption consumption

(litres/cycle) (kWh/cycle)

3:35

9.5

0.95

2:40

18.0

1.60

2:15

16.0

1.40

Fast Wash&Dry 50° - Normally soiled crockery. Everyday cycle, that ensures optimal cleaning and drying performance in shorter time.

Rapid 28' 50° - Program to be used for half load of lightly-soiled dishes with no dried food residues. Does not have drying phase.

Silent 50° - Suitable for night-time operation of the appliance.

Ensures optimal cleaning and drying performance with the lowest

noise emission.

Hygiene 65° - Normally or heavily soiled crockery, with additional

antibacterial wash. Can be used to perform maintenance of

the dishwasher.

Prewash - Use to refresh crockery planned to be washed later. No detergent to be used with this program.

Self-Clean 65° - Program to be used to perform maintenance of the

dishwasher, to be carried out only when the dishwasher is EMPTY

using specific detergents designed for dishwasher maintenance.