Instruction Manual for sunlite models including: 88142-SU LFX-T-UD-12 -24W-BK-SCT, 88142 LED Outdoor Up and Down Light, 88142, LED Outdoor Up and Down Light, Outdoor Up and Down Light, Up and Down Light, Light
1 giorno fa — Step 1 – Preparing for installation. A. Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture.
SCT UP/DOWN TUBULAR FIX | 88142-SU LFX/T/UD/12''/24W/BK/SCT MIN 75°C SUPPLY CONDUCTOR. Turn off the power at fuse or circuit breaker box before installation and maintenance. NOTE: This fixture is suitable for 120-277Volts fused circuit. Fixture must be installed according to National Electric Code and local building codes. If you are unsure about wiring, consult a qualified electrician. Suitable for wet Locations. Before beginning assembly and installation of product, make sure all parts are present. Compare parts with package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate the product. Contact customer service for replacement parts. HALF HEXAGON WALL SCONCE Wire Nuts 4X30MM Screws Assembly Instructions JUNCTION BOX Step 1 Preparing for installation. A. Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture. B. Carefully remove the fixture from the carton and check that all parts are included. C. Disassemble mounting bracket (1) from the backboard (3) by removing all necessary components per illustration shown. D. Install mounting bracket (1) to the junction box (not included). Wiring-all wiring must take place inside junction box (not included). Step 2 Wiring fixture. A. Make all wire connections to appropriate wire. Secure with wire nuts (provided). B. Connect the bare wire from the fixture and the supply power source ground wire. C. Connect the black wire from the fixture to the black (L) wire from supply power source. D. Connect the white wire from the fixture to the white (N) wire from supply power source. E. Pull on each wire lead to make sure connections are secure. Make certain no bare wires are exposed outside of wire connectors. Tuck all connections neatly into the junction box. GROUND SCREW 1 2 3 4 CCT Color Switch Step 3 Color changing temperature adjustment, CCT (if desired) Adjust CCT switch on the module of the fixture according to the desired color temperature as shown below. Note: Fixture is preset to 3000K from factory. Step 4 Mounting. A. Place the backboard (3) on the mounting bracket (1), install the backboard (3) by twisting finials (4). Make sure the unit against the surface of the wall. B. Apply a small amount of silicone (not included) per manufacturer's instruction around finials (4) and around the backboard contacts with the surface of the wall. Step 5 Restore power at fuse or circuit breaker box.Adobe PDF library 15.00