Instruction Manual for NW 1776 models including: 2BKMU-X1, 2BKMUX1, X1 Wireless Bluetooth Speaker, X1, Wireless Bluetooth Speaker, Bluetooth Speaker, Speaker
shenzhenshiwanwuhuliumaoyiyouxiangongsi X1 2BKMU-X1 2BKMUX1 x1
NN X1--- X1 40mm 4 3W 500mAh 5V 200mAh 10 DC5V 2 2.5 5.0*5.0*3.6CM 125g / / / MIC / / Type-C5V/200mAh MIC 128G K 1 2 MIC 3 "" 4USBUSB 55 NN WIRELESS BLUETOOTH SPEAKER Product instruction manual Product Specification Model: X1 Speaker: 40mm 4 3W Battery capacity: 500mAh Input: 5V 200mAh Bluetooth distance: 10 meters Working voltage: DC5V Charging time: about 2 hours Playing time: about 2.5 hours Product size: 5.0*5.0*3.6CM Product weight: about 125g Product Illustration : Power On/Off Play/Pause Answer/Reject button : Function Alert Light Power Input MIC hole Function Display On/Off button: double-click Short press Long press Dual-machine coupling function Play/pause, answer phone calls. Turn on/off, Reject calls. Blue light flashing Bluetooth pairing in progress. Function prompt light: Blue light always on Bluetooth is connected. Red light always on Normal charging in progress. Power input port: Support Type-C, 5V/200mAh charging cable. MIC holes: Microphone Receiver Hole. Operating Guidelines 1: Music playback: long press the switch button, the blue light flashes, open the cell phone bluetooth, connect the product pairing name, pairing success, pairing success after the blue light is always on. 2: Call function: switch button can be long-pressed to realize the rejection of calls, short press to answer, call as close as possible to the MIC hole. 3: Dual-machine coupling function: two machines waiting for the Bluetooth connection status, take any one machine double-click the switch button, "beep" and then through the cell phone to connect to the Bluetooth, you can be coupled. 4: USB charging: after plugging in the charging cable, the red light is on when USB charging, the red light goes out when the battery is fully charged. 5: The product will automatically shut down if the cell phone is not connected to Bluetooth within 5 minutes. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restrictionAdobe PDF library 17.00 Adobe Illustrator(R) 24.0