Off Road LED Light Bars & Pods for Trucks by RigidWarranty Information
Installation Guide for RIGID models including: E-SERIES PRO, E-SERIES PRO 20 Inch Spot Hyperspot Combo, 20 Inch Spot Hyperspot Combo, Spot Hyperspot Combo, Hyperspot Combo, Combo
RIGID Industries E-Series Pro 10" Spot - Black RIGID INDUSTRIES110213
RIGID Industries E-Series Pro 10" Spot - Black
File Info : application/pdf, 2 Pages, 836.25KB
DocumentDocumentINSTALLATION INSTRUCTIONS E-SERIES PRO® & SR-SERIES PRO® PRODUCT INCLUDES: (1) RIGID LED Light Bar (1) Wiring Harness w/ Switch All Mounting Hardware IMPORTANT THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE. Please read through all of these Instructions and tips before proceeding with the installation. We do our best to provide a simple installation process for all applications however a professional installation is always recommended. Always disconnect any power sources connected to your vehicle before servicing fuses or electrical systems. STEP 1 Mounting: Insert mounting brackets onto the light as shown in Figure 1. Secure hardware to a snug position and mount your light into desired location. FIGURE 1 See Figure 1 WIRING INSTRUCTIONS Wiring Harness Fuse To Light Bar Negative & Positive Relay Switch To Battery Negative & Positive 1. Locate a suitable, "high and dry" location to mount the relay, close to the vehicle battery, in the engine compartment. 2. When routing wire harness through the vehicle firewall (or any sheetmetal panel), make sure there are no sharp edges that could damage your harness. Protect the harness from damage by using a grommet and/or loom and tape. 3. Route the harnesses through the vehicle to their general locations. 4. Switch should be mounted in cab. Route the switch leads to desired dash location. Mount the switch. (Drilling + file-fitting may be required.) Connect wiring as shown below. 5. Connect light bar flying leads to positive and negative harness leads. (RED wire is positive, BLACK wire is negative.) 6. Connect positive and negative battery terminals to vehicle battery. (RED wire is positive, BLACK wire is negative.) 7. Test functionality and adjust / aim your lightbar. 8. Tighten mounting hardware to 75 in-lbs. (~6 ft-lbs) SWITCH WIRING NOTE: GOLD Spade is the Top of Switch, 3/4" mounting hole required Black Wire 1 = Switch Ground Blue Wire/Red Wire w/ Heat Shrink 2 = Switch Output to Relay 3 Red Wire = Switch Input Power WARRANTY INFORMATION For warranty information, visit www.rigidindustries.com/about/warranty 779 N Colorado St, Gilbert, AZ 85233 · 855-760-5337 www.rigidindustries.com E-Series and SR-Series, RIGID, and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries. 11-13836-A