Instruction Manual for MULTIVERSE models including: PTTCC004 Modular Tenement, PTTCC004, Modular Tenement, Tenement
Instructions – Multiverse PTTCC001 S.T.A.C.K. ContainersPTTCC002 S.T.A.C.K. Tanks PTTCC003 Hardware Shed
1 2 Assemble the top (cable+plate) and the bottom of the neons separately and then add the top piece to the bottom one. Glue the top roof pieces to the bottom ones as shown, covering the holes. 3 4 Start the assembly of the main module with this piece. 1 Add the floor piece to the model as shown (with the narrow protrusion in line with the wall and the wide protrusion on the opposite end). 5 Add the wall with the door to the model. 6 Add the rear wall to the model as shown. 2 7 8 Add all the narrow steps to the wall with the entrance as shown (with the slanted side pointing outside). Add this wall to the model. If the steps don't line up with the holes, place your finger behind them and push them slightly until all the steps sit firmly between two walls. 9 10 Glue the topmost step to the stairway as shown. 3 Remove the protective film and place the lower protrusion on the door into the hole in the lowest step. Place the hinge on top of the door and carefully push it into the slit. 11 12 e assembled hinge should look like this. Add the two corner pieces to the model as shown. 13 14 Add this wide wall piece to the model. Add the external wall piece with window to the other side of the module. 4 15 Add the floor support piece to the model as shown here. 16 Glue the bar with hazard stripes to the front of the model as shown. 5 17 18 Place the first floor piece inside and slide it under the bottom hinge. 6 19 Add the second half of the floor to the model. 20 Assemble the floor hatch as shown. 7 21 Place the floor hatch into the hole in the floor. 8Adobe PDF Library 16.0.5 Adobe InDesign 17.1 (Windows)