User Manual for JIECANG models including: W1B, 2B, JCHR35W1B-2B 6-Channel LCD Remote Controller with Timer, JCHR35W1B-2B, 6-Channel LCD Remote Controller with Timer, 6-Channel, LCD Remote Controller with Timer, LCD Remote Controller, Controller with Timer
29 nov 2022 — The transmitter should not be exposed to moisture or impact, so as not to affect its life. During use, when the remote control distance is significantly ...2 pagine
OCGs[9 0 R 61 0 R 112 0 R 163 0 R 215 0 R 273 0 R 331 0 R]>>/Pages 3 0 R/Type/Catalog>> endobj 2 0 obj >stream 2022-10-06T17:00:29 08:00 Adobe Illustrator 26.3 ...
User Manual 01 Product Info Wall-mounted 6-channel LCD Prg T Prg Wall-mounted 6-channel LCD 02 Models & Parameters (more info please refer to the nameplate) b.Number of Channels Setting 03 Caution! 1. The transmitter should not be exposed to moisture or impact, so as not to affect its life 2. During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced. 3. When the battery voltage is too low, the LED screen will show a low voltage prompt, prompting to replace the battery. 4. Please properly dispose of used batteries according to the local garbage classification and recycling policy. 04 Instructions a.Channels & Groups Toggling c.Number of Groups Setting d.Channel in Group Setting Short press , if you want the Channel in the group, the Channel number will be steady-lit. Short press again, if you want the Channel not in the group, the Channel number will be flashing. e.Check the Channels in Groups Channel 0 is where all channels are shown as steady-lit. f.Prohibit Dual-key Operation i.Local Time Setting Steady-lit Days will be inclueded in the timer program; flashing Days will not included in the timer program. g.Position Percent Setting h.Modes Toggling Toggle in cycle function Stop on the desired percentage down and wait 3s. The shades will move to the chosen percentage down position. Week Icon Flicker Set Up hour Set Up minute Set Down hour j.Timer Control Eneter program mode Set Down minute program mode Program 1 program mode program mode Program 2 Program 20 invalid. Steady-lit channel numbers will be inclueded in the timer program; flashing channel numbers will not included in the timer program. k.For other operations, please refer to the motor operation instructionAdobe PDF library 16.07