Instructions for SOUND AROUND models including: PPHP1599WU, PPHP1599WU Wireless Handheld Microphone, Wireless Handheld Microphone, Handheld Microphone
Sound Around INC. PPHP1599WU microphone 2A6FX-PPHP1599WU 2A6FXPPHP1599WU pphp1599wu
microphone PPHP1599WU Microphone parameter Product name Product frequency Operating voltage microphone 600.85MHz-606.02MHz DC 3V5# 1.5V*2) Working current >1 10mA Dynamic range >105dB Frequency response 20Hz- 18KHz Signal-to-noise ratio >98dB pickup Moving-coil type Frequency Maximum frequency offset ±10 KHz Continuous service time About 6-8 hours Modulation mode FM Hardware version number V4 .2 20230320 Software version number 0643 V8 . 1 Power switch Battery holder operation instructions 1. Unscrew the tailpipe and install 2 AA5 batteries (2x 1.5V). Note: the polarity of the battery should not be reversed 2 Press the power button, the microphone display will light up, and the microphone will enter the standby state. Then turn on the receiver and wait for the microphone to connect to the receiver. Turn off the microphone and press the power button again. 3. When the microphone is in use, the display flashes, indicating that the battery power is fast enough to support the normal operation of the microphone, and the battery must be replaced in time (Warm tip: The microphone is not used for a long time, please take out the battery to avoid battery liquid leakage corrosion circuit board, causing damage) FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC Radiation Exposure Statement This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The device can be used in portable exposure condition without restriction.Microsoft Office Word Aspose.Words for .NET 15.1.0.0