User Manual for Pro-Ject models including: Tristand Loudspeaker, Tristand, Loudspeaker

Manual

Tristand – Pro-Ject Audio Systems

Tristand

Before assembly please make sure all parts are included. Step 1. As shown in the picture below, take the top plate and one of the two steel pro les.

5 days ago — Before assembly please make sure all parts are included. Step 1. As shown in the picture below, take the top plate and one of the two steel pro les.1 page

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 1 Pages, 109.45KB

Document Document

Tristand

 · 1x base plate

 · 1x top plate

Size without feet (W x D x H): 328 x 328 x 678 mm Size with feet (W x D x H): 328 x 328 x 700 mm Top plate surface (W x D): 150 x 142 mm Weight per Tristand: 5 kg Maximum load per Tristand: 20 kg
Before assembly please make sure all parts are included.
Step 1
As shown in the picture below, take the top plate and one of the two steel proles marked with no. 1 and attach them together. Screw the top plate and steel prole together (using a M4x14 screw and the included allen key), but do not tighten the screw completely yet.

Step 2
Take another steel prole now with mark no.2, and attach it in the opposite direction to the previous one into the hole above the rst steel prole (as shown in the picture below). Don't tighten the screws completely.

Steel prole points in that direction

Step 5
Take the base plate and put it on the steel proles from the other side. Align the threads with the holes in the base and screw them together. At rst don't tighten the screws completely. Once you have all screws in the threads, tighten them. Afterwards, also tighten the screws on the top plate (steps 1 ­ 4).

Steel prole points in that direction
Step 6
Screw the nuts onto the spike feet.
Then screw the feet into the base. Carefully lift the assembled Tristand up, place it on the ground and put the cups under the spike feet. You can now tighten or loosen the spike feet to ensure the base is level (use a spirit level if necessary).

 · 2x steel proles (marked no. 1)

 · 2x steel proles (marked no. 2)

 · 4x M4x14 allen screws  · 1x 2,5mm allen key
 · 3x M8 nuts  · 3x spike feet

Step 3
Repeat step 2 with another steel prole.

 · 3x cups for spike feet  · 4x M5x20 spikes  · 4x M5 nuts
Step 4
Repeat step 1 with another steel prole marked no. 1 in the same direction as in step 1.

Steel prole points in that direction

Steel prole points in that direction

Step 7
Now you are ready to place the speaker on the Tristand. You have two options on how to do that.
1) Directly place the speaker onto the microporous rubber pads on top plate.
2) Screw the M5x20 spikes into the threads located in the middle of the microporous rubber pads. Adjust the height until the speaker has a proper stand and lock the screw with a nut from the bottom.

Pro-Ject Audio Systems is a division of Audio Tuning Vertriebs GmbH Margaretenstrasse 98, A-1050 Vienna, Austria