Lutron® Smart Bridge
Please read before installing
Contents supplied:
Lutron® Smart Bridge *
(L-BDG, BDG-1 or L-BDGPRO)
5 V
300 mA
Power Supply
(T-5DC-USB)
Input: 100–240 V~ 50/60 Hz 100 mA
Output: 5 V 550 mA
Ethernet Cable
* Connected to a Class 2, LPS, or SELV, limited energy (<15 W) power source only.
Double your warranty
Love LutronR products? Have ideas for making them better? Tell us what you think and we’ll extend your warranty by 1 year.
www.casetawireless.com/register
Install the Lutron® Smart Bridge
A. Connect the Smart Bridge to your Wi-Fi router using the Ethernet cable.
B. Connect the power cord to the Smart Bridge and plug it into an outlet.
Download the Lutron® app and walk through setup
www.casetawireless.com/LutronApp
Apple is a trademark of Apple Inc., registered in the U.S. and other countries.
App Store is a service mark of Apple Inc., registered in the U.S. and other countries.
Accessory Setup Code
Warranty
For warranty information, please visit www.casetawireless.com/warranty
Lutron and Lutron are registered trademarks and
Lutron™ is a trademark of Lutron Electronics Co., Inc. Google and the Google logo are registered trademarks of Google Inc., used with permission.
© 2014 – 2015 Lutron Electronics Co., Inc.
FCC/IC Information
This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation. Modifications not expressly approved by Lutron Electronics Co., Inc. could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Documents / Resources
 |
LUTRON L-BDG2 Smart Bridge WiFi Router [pdf] User Guide L-BDG2, L-BDGPRO2, T-5DC-USB, L-BDG2 Smart Bridge WiFi Router, Smart Bridge WiFi Router, Bridge WiFi Router, WiFi Router, Router |