LTECH KDT ELV Module Instruction Manual

LTECH KDT ELV Module

Product Introduction

• DALI to Triac/ELV protocol: Seamless expansion to meet diverse lighting control requirements.
• It adopts the latest DALI-2 interface and fully supports DALI DT6 devices to ensure compatibility with the latest technology.
• Supports DALI control and PUSH DIM switch control, providing users with a more flexible operation experience.
• A short press can control the load switch, and a long press can adjust the brightness. The operation is simple and intuitive.
• Support setting the dimming output signal via NFC, and you can choose either the leading-edge Triac or the trailing-edge ELV output.
• Support configuring DALI addresses and setting the minimum brightness value of the load via NFC.
• Compact size, multi-specification compatibility: Compatible with European, American, and Chinese standard base boxes, flexible installation, suitable for various scenarios.

Technical Specifications

Product Illustration

Dimension

Product Size

Wiring Diagram

1. Wiring diagram for DALI signal input.
2. Wiring diagram for connecting a single PUSH switch.
3. Wiring diagram for connecting multiple PUSH switches.

Use The NFC Lighting APP

• Scan the QR code below with your mobile phone and install the APP as prompted.
• (Due to performance requirements, the required phone model is Apple: iPhone8 or above, and the operating system iOS13 or above; Android: NFC-enabled models)

1. Read the device
   Click “Read / Write LED driver” in the APP [home page], place the sensing area of the phone near the NFC identification point of the driver, and read the device parameters.
2. Edit parameters
   Click “Parameter Management” to select and edit parameters such as DALI address, dimming curve, brightness range, dimming gradient time, power-on status, and DALI advanced template Settings.

Attention

• Product installation and commissioning should be done by a qualified professional. Our company products are not lightningproof or waterproof (special models excepted).
• Please avoid the sun and rain. When installed outdoors, please ensure they are mounted in a waterproof enclosure or in an area equipped with lightning protection devices. Good heat dissipation will prolong the working life of products.
• Please ensure good ventilation.
• Please check if the working voltage used complies with the parameter requirements of the products.
• The diameter of the wire used must be able to support the light fixtures you connect and ensure proper wiring.
• Before you power on products, please make sure all the wiring is correct in case of an incorrect connection that causes damage to light fixtures.
• If a fault occurs, please do not attempt to fix the products by yourself. If you have any questions, please contact your suppliers.

Warranty Agreement

• Warranty periods from the date of delivery: 5 years.
• Free repair or replacement services for quality problems are provided within warranty periods.

Warranty exclusions below:
Following conditions are not within the guarantee range of free repairing or replacement services:

• Beyond warranty periods.
• Any artificial damage caused by high voltage, overload, or improper operations. Products with severe physical damage.
• Damage caused by natural disasters and force majeure.
• Warranty labels and barcodes have been damaged.
• No contract signed by our company.

1. Repair or replacement provided is the only remedy for customers. Our company is not liable for any incidental or consequential damage unless it is within the law.
2. Our company has the right to amend or adjust the terms of this warranty, and any release in written form shall prevail.

This manual is subject to changes without further notice. Product functions depend on the goods. Please feel free to contact our official distributors if you have any questions.