LP Adjustable Beds Bas-X HCS Adjustable Base Remote Control

REMOTE CONTROL FUNCTION

REMOTE CONTROL PROGRAMMING – 1 REMOTE TO OPERATE 1 BASE

STEP 1
Plug remote control cord into base motor cable (FIGURE 1). Pivot cable latch downward and snap cable latch in closed position (FIGURE 1).
NOTE: ALIGN PINS BEFORE INSERTING PLUGS
(FIGURE 1). DO NOT WEAVE CORDS THROUGH BASE STRUCTURE.

STEP 2
Plug electrical power cord into a working, grounded electrical outlet.
NOTE: AN ELECTRICAL SURGE PROTECTION DEVICE IS RECOMMENDED (NOT INCLUDED).

STEP 3
Operate the remote control to verify the base functions correctly.

WARNING POWER CORDS MUST NOT INTERFERE WITH ANY ADJUSTABLE BASE MECHANISMS. DO NOT WEAVE CORDS THROUGH BASE STRUCTURE.

TANDEM SYNCING

To tandem sync two bases to operate as one base, perform the following procedure:

WARNING POWER CORDS MUST NOT INTERFERE WITH ANY ADJUSTABLE BASE MECHANISMS. DO NOT WEAVE CORDS THROUGH BASE STRUCTURE.

STEP 1
Locate the sync cable (FIGURE 2).

STEP 2
Unplug both remote control cords from respective base motor cables.

STEP 3
Plug (1) male end of sync cable into motor cable of base 1; place the other male end of sync cable into motor cable of base 2 (FIGURE 2).

STEP 4
Plug (1) remote control cord into female end of sync cable (FIGURE 2).
Second remote is not needed. Retain for future use.

TROUBLESHOOTING

If the adjustable base fails to operate, investigate the symptoms and possible  solutions provided in the chart below:

 

SYMPTOM	SOLUTION
Remote control will not activate base	Verify power cord is plugged into a working, grounded electrical outlet. A grounded, electrical surge protection device is recommended. Test outlet by plugging in another working appliance. Verify remote control is plugged into the motor. Unplug power cord, wait 30 seconds and plug in to reset electronic components. Electrical circuit breaker may be tripped. Check electrical service breaker box to verify. Defective surge protection device or electrical outlet. Test outlet by plugging in another working appliance.
Head section will elevate, but will not return to the horizontal (flat) position.	Base mechanism may be obstructed. Elevate base and check for obstruction. Remove obstruction. Head section may be too close to the wall

CUSTOMER SERVICE toll free: 800-888-3078

Documents / Resources

LP Adjustable Beds Bas-X HCS Adjustable Base Remote Control [pdf] User Guide Bas-X HCS Adjustable Base Remote Control, Bas-X HCS, Bas-X HCS Remote Control, Adjustable Base Remote Control, Remote Control

References

• User Manual