Main Frame
- Top Corner (x2)
- Shock-corded Horizontal Top Pole
- Shock-corded Horizontal Bottom Pole
- Top Sides (x4)
- Middle Sides (x2)
- Bottom Sides (x4)
- Table Clamps (x2)
- Main Graphic
- Top or Bottom Ends (x4)
- Shock-corded Sides (x4)
- Side Clamps (x4)
- Side Graphics (x2)
Mainframe
Separate the Main Frame parts from the Sides. Unfold the Shock-corded Poles and secure them in their extended positions. Connect all of the poles together by matching each number to its counterpart.
Side Frames
Construct the Sides in the same way by matching numbers and clicking push buttons into place.
Storage & Care
Store in a cool dry location. Clean hardware with a damp cloth. Machine wash the graphics in cold water on a gently cycle. Air dry only. Use a steamer for wrinkles. Never dry-clean.
Install The Graphics
Fit the Main Graphic to the Main Frame and the side graphics to the Side Frames. Zip them closed.
Mount the Table Clamps
Mount the Tale Clamps on the ends of the table by tightening the screws on their undersides. Once the clamps are secure, carefully lower the main frame onto them so that the Bottom Sides slide onto the lack cylinders
Side Clamps
Attach one side of each Side Clamp to the sides of the Main Frame. One goes directly under the graphic and one above the table Clamp. Carefully lift each of the Sides to be level with the main frame
and attach them to the open ends of the Side Clamps.
Storage & Care
Store in a cool dry location. Clean hardware with a damp cloth. Machine wash the graphics in cold water on a gently cycle. Air dry only. Use a steamer for wrinkles. Never dry-clean .
Documents / Resources
 |
LookOurWay Custom Table Top Banner Display [pdf] Instruction Manual Custom Table Top Banner Display, Custom Table Top Banner Display, Banner Display, Display |
