logitech Wireless Headset H600 User Guide

logitech logo

logitech Wireless Headset H600 User Guide

logitech Wireless Headset H600

 

KNOW YOUR PRODUCT

FIG 1 KNOW YOUR PRODUCT

 

FIG 2 KNOW YOUR PRODUCT

 

CHARGING AND CONNECTING THE HEADSET

  1. Connect the headset to a computer using the USB-A charging cable.
    Charge the headset for 3 hours or until the status light turns solid green.
  2. Connect the USB-A receiver to a USB-A port on the computer
    (connecting to a USB hub isn’t recommended). Power on your headset.

FIG 3 CHARGING AND CONNECTING THE HEADSET

 

FIG 4 CHARGING AND CONNECTING THE HEADSET

 

HEADSET FIT

  1. Adjust headset size by moving the headband up and down until it fits comfortably.
  2. Move the microphone boom up or down until it is level with your mouth for better voice capture.
  3. Tuck the right-sided boom inside the headband and out of the way when you’re not using it.
  4. Fold up the lightweight headset like sunglasses for portability.

FIG 5 HEADSET FIT

FIG 6 HEADSET FIT

 

www.logitech.com/support/H600

© 2019 Logitech. Logitech, Logi and other Logitech marks are owned by Logitech and may be registered. All other trademarks are the property of their respective owners. Logitech assumes no responsibility for any errors that may appear in this manual. Information contained herein is subject to change without notice.

 

logitech logo

 

Read More About This Manual & Download PDF:

Documents / Resources

PDF thumbnailWireless Headset H600
User Guide · Wireless Headset H600

References

Questions and answers

Helpful product questions tied to this manual. Each item links to the full Q&A page.

Questions & Answers

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

  1. The status light does not turn on when connected to a PC.
    It will flash orange for about a minute and then turn off.
    I thought it might be hard to see because it was green, so I checked it in the dark just in case, but it didn’t fall over.
    Is it a malfunction?
    PCに接続してもステータスライトが点灯しません。
    1分程度オレンジで点滅し、その後明かりが消えてしまいます。
    緑になって見えづらいのかと思い、念のため暗がりでも確認しましたが、転倒していませんでした。
    故障でしょうか?

    山﨑安那 asks <em>The status light does not turn on when connected to a PC.
    It will flash orange for about a minute and then turn off.
    I thought it might be hard to see because it was green, so I checked it in the dark just in case, but it didn't fall over.
    Is it a malfunction?<e/em>
    PCに接続してもステータスライトが点灯しません。
    1分程度オレンジで点滅し、その後明かりが消えてしまいます。
    緑になって見えづらいのかと思い、念のため暗がりでも確認しましたが、転倒していませんでした。
    故障でしょうか?
    Manuals+ clarified question
    Question

    Why does the status light flash orange for a minute and then turn off when connected to a PC?

    Answer

    Based on the Logitech H600 User Guide, the status light behavior you are describing indicates a charging or power issue. Here are the steps to troubleshoot and understand the light indicators:

    • Charging Status: When the headset is connected to a computer via the USB-A charging cable, it should be charged for 3 hours or until the status light turns solid green.
    • Orange Flashing: A flashing orange light typically indicates that the battery is low or currently charging. If it turns off after a minute, it may suggest the headset is not receiving a consistent charge or the battery is unable to hold a charge.
    • Connection Check: Ensure the USB-A charging cable is plugged directly into a computer port. The manual notes that connecting to a USB hub is not recommended as it may not provide sufficient power.
    • Power Switch: Ensure the power switch is in the correct position. After charging, you must power on the headset to establish a wireless connection with the Nano receiver.

    If the light continues to turn off prematurely and the headset does not function wirelessly after a full 3-hour charge attempt, it may indeed indicate a hardware malfunction or a depleted battery.

    For further assistance, you can visit the official support page at logitech.com/support/H600.

    Note: The manual does not explicitly define a "flashing orange then off" sequence as a specific error code, so this troubleshooting is based on standard charging procedures.

    Japanese Summary (日本語要約):
    マニュアルによると、充電中はステータスライトが点灯し、完全に充電されると緑色の点灯に変わります。オレンジ色の点滅は通常、充電中またはバッテリー残量が少ないことを示しますが、1分で消えてしまう場合は、充電が正しく行われていないか、バッテリーの不具合の可能性があります。USBハブではなく、PCのUSBポートに直接接続して3時間充電を試してください。それでも改善しない場合は、故障の可能性があります。

  2. You have a lot of ads for software to print manuals…and all I needed was how to connect the headset via bluetooth…and that information is not here. Rude to call this a manual when there is barely any information let alone an actual manual with instructions.

    Joan Johnson Porter asks You have a lot of ads for software to print manuals...and all I needed was how to connect the headset via bluetooth...and that information is not here. Rude to call this a manual when there is barely any information let alone an actual manual with instructions.
    Manuals+ clarified question
    Question

    How to connect the headset via Bluetooth?

    Answer

    The Logitech Wireless Headset H600 connects to your computer using a USB-A wireless nano receiver, not via Bluetooth. The manual describes the connection process as follows:

    1. Connect the headset to a computer using the USB-A charging cable. Charge the headset for 3 hours or until the status light turns solid green.
    2. Connect the USB-A receiver to a USB-A port on the computer (connecting to a USB hub isn't recommended).
    3. Power on your headset.

    This information is found on page 4 of the provided manual, under the section "CHARGING AND CONNECTING THE HEADSET."

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.