Use the vendor app
- Username
- Not specified
- Password / access
- Vendor app or account
Access: App
Vilo Mesh Wi-Fi
Source (opens in a new tab)ROUTER & MODEM REFERENCE
Vilo router & modem login
Login addresses, default credentials, and setup instructions for Vilo equipment.
A shared web login address is not listed for this equipment. Check the model instructions below for app access, the device label, or your router’s gateway address.
Connect to the router’s Wi-Fi or Ethernet first. These links open a new tab on your device; the address may differ if the network was reconfigured.
QUICK START
Most likely login options
Start with the option that matches your model. Defaults apply to the factory state; use the password you chose if the device has already been set up.
Options are ordered by manufacturer documentation and coverage among the listed models. Hardware, firmware, and ISP versions can differ.
MODEL DETAILS
Login addresses & credentials
Passwords are case-sensitive. “Leave blank” means an empty field; “Not specified” means the source does not provide that detail. Entries without a model are brand-level references.
| Model / device | Login address | Username | Password / access | Notes & source |
|---|---|---|---|---|
| ViloVilo Mesh Wi-FiMesh system · App | App / account access | Not specified | Vendor app or account | App-only — Vilo does not expose a web admin interface. There is no admin/admin default. The Wi-Fi name and password printed on the bottom label are only used to join the pod during app setup; you set your own network password in the app. Recovery & reset instructionsVilo has no 192.168.x.x web login — configuration is done entirely in the Vilo mobile app. To factory reset: use a paperclip or pin to press and hold the reset button on the back of the Vilo for about 6 seconds until the light on the front flashes red. Then add the Vilo back in the app; the default network name and password used to join during setup are printed on the bottom of the pod. |
No records match these filters. Try another model or clear the filters.
GET CONNECTED
How to reach your router
- Connect your computer or phone to the router’s Wi-Fi or an Ethernet port.
- Open a documented login address. If it does not load, look for the Router or Default gateway address in your device’s network settings.
- Match your model and hardware revision to the table. Use the device label or your setup password when the model has no shared default.
Admin password or Wi-Fi password?
The admin password opens the router’s settings. The Wi-Fi password connects a device to the wireless network. They may be different, and an ISP or cloud account can be separate again.
If the password does not work
Check capitalization and the device label, then use the manufacturer’s password-recovery instructions. A factory reset erases settings and may require ISP setup details; follow the instructions for your exact model.
Find your model’s manual →Sources & data
Router default-credential data from ssid.ai (Drumworks Ventures FZ), licensed CC BY 4.0. Adapted, organized and supplemented by Manuals+. The data is provided as is; manufacturers and ISPs can change defaults.
Additional factual entries: Austin Songer’s credential list and Clint Milner’s credential list. Each table entry links to its supporting source. Updated 2026-10-16.