Check the device label
- Username
- admin
- Password / access
- Password on the device label
Access: Web
Hub One, Hub Two
Source (opens in a new tab)ROUTER & MODEM REFERENCE
Plusnet router & modem login
Login addresses, default credentials, and setup instructions for Plusnet equipment.
Connect to the router’s Wi-Fi or Ethernet first. These links open a new tab on your device; the address may differ if the network was reconfigured.
QUICK START
Most likely login options
Start with the option that matches your model. Defaults apply to the factory state; use the password you chose if the device has already been set up.
Options are ordered by manufacturer documentation and coverage among the listed models. Hardware, firmware, and ISP versions can differ.
MODEL DETAILS
Login addresses & credentials
Passwords are case-sensitive. “Leave blank” means an empty field; “Not specified” means the source does not provide that detail. Entries without a model are brand-level references.
| Model / device | Login address | Username | Password / access | Notes & source |
|---|---|---|---|---|
| PlusnetHub OneModem / gateway · Web | http://192.168.1.254 (opens in a new tab) | admin | Password on the device label | No universal default. The Plusnet Hub One uses username 'admin' plus a unique admin password printed on the back-of-hub card/sticker. Recovery & reset instructionsTo log in: connect to the hub, browse to 192.168.1.254, enter username 'admin' and the Hub admin password from the card/sticker on the back of the hub. To factory reset: with the hub powered on, press and hold the recessed Reset button on the back for about 20 seconds until the lights flash; the admin password returns to the value printed on the back. |
| PlusnetHub TwoModem / gateway · Web | http://192.168.1.254 (opens in a new tab) | admin | Password on the device label | No universal default password. Each Hub Two ships with a unique admin password printed on a card/sticker on the back of the hub; the username is 'admin'. Recovery & reset instructionsTo log in: connect to the hub, browse to 192.168.1.254, enter username 'admin' and the Hub admin password printed on the card/sticker on the back of the hub. To factory reset: with the hub on, press and hold the recessed Reset button on the back for about 20 seconds until the lights flash and it reboots; the admin password reverts to the one printed on the back. |
No records match these filters. Try another model or clear the filters.
Related login addresses
GET CONNECTED
How to reach your router
- Connect your computer or phone to the router’s Wi-Fi or an Ethernet port.
- Open a documented login address. If it does not load, look for the Router or Default gateway address in your device’s network settings.
- Match your model and hardware revision to the table. Use the device label or your setup password when the model has no shared default.
Admin password or Wi-Fi password?
The admin password opens the router’s settings. The Wi-Fi password connects a device to the wireless network. They may be different, and an ISP or cloud account can be separate again.
If the password does not work
Check capitalization and the device label, then use the manufacturer’s password-recovery instructions. A factory reset erases settings and may require ISP setup details; follow the instructions for your exact model.
Find your model’s manual →Sources & data
Router default-credential data from ssid.ai (Drumworks Ventures FZ), licensed CC BY 4.0. Adapted, organized and supplemented by Manuals+. The data is provided as is; manufacturers and ISPs can change defaults.
Additional factual entries: Austin Songer’s credential list and Clint Milner’s credential list. Each table entry links to its supporting source. Updated 2026-10-16.