Use the vendor app
- Username
- Not specified
- Password / access
- Vendor app or account
Access: App
Nest Wifi / Google Wifi, Nest Wifi Pro
Source (opens in a new tab)ROUTER & MODEM REFERENCE
Google router & modem login
Login addresses, default credentials, and setup instructions for Google equipment.
A shared web login address is not listed for this equipment. Check the model instructions below for app access, the device label, or your router’s gateway address.
Connect to the router’s Wi-Fi or Ethernet first. These links open a new tab on your device; the address may differ if the network was reconfigured.
QUICK START
Most likely login options
Start with the option that matches your model. Defaults apply to the factory state; use the password you chose if the device has already been set up.
Options are ordered by manufacturer documentation and coverage among the listed models. Hardware, firmware, and ISP versions can differ.
MODEL DETAILS
Login addresses & credentials
Passwords are case-sensitive. “Leave blank” means an empty field; “Not specified” means the source does not provide that detail. Entries without a model are brand-level references.
| Model / device | Login address | Username | Password / access | Notes & source |
|---|---|---|---|---|
| Google–Router · Not specified | – | admin | urchin | Model not specified by this list. |
| GoogleNest Wifi / Google WifiMesh system · App | App / account access | Not specified | Vendor app or account | App-only: setup and management are entirely through the Google Home app. There is NO web admin page, NO default IP login, and NO default username/password. Recovery & reset instructionsFactory reset via the Google Home app (Wi-Fi › Settings › Factory reset network), or hold the factory-reset button on the point until the light pulses. |
| GoogleNest Wifi ProMesh system · App | App / account access | Not specified | Vendor app or account | App-only via the Google Home app. There is no admin/admin default; you create the network name and password during setup. Nest Wifi Pro cannot be mixed in a mesh with older Nest Wifi or Google Wifi points. Recovery & reset instructionsNest Wifi Pro has no web admin — it is set up and managed in the Google Home app. To factory reset the router: press and hold the factory reset button on the bottom for about 10 seconds; the light flashes yellow, then turns solid yellow — release the button. The reset can take up to 10 minutes; do not unplug during it. Then open the Google Home app and set the device up again (you pick a new network name and password). |
No records match these filters. Try another model or clear the filters.
GET CONNECTED
How to reach your router
- Connect your computer or phone to the router’s Wi-Fi or an Ethernet port.
- Open a documented login address. If it does not load, look for the Router or Default gateway address in your device’s network settings.
- Match your model and hardware revision to the table. Use the device label or your setup password when the model has no shared default.
Admin password or Wi-Fi password?
The admin password opens the router’s settings. The Wi-Fi password connects a device to the wireless network. They may be different, and an ISP or cloud account can be separate again.
If the password does not work
Check capitalization and the device label, then use the manufacturer’s password-recovery instructions. A factory reset erases settings and may require ISP setup details; follow the instructions for your exact model.
Find your model’s manual →Sources & data
Router default-credential data from ssid.ai (Drumworks Ventures FZ), licensed CC BY 4.0. Adapted, organized and supplemented by Manuals+. The data is provided as is; manufacturers and ISPs can change defaults.
Additional factual entries: Austin Songer’s credential list and Clint Milner’s credential list. Each table entry links to its supporting source. Updated 2026-10-16.