Check the device label
- Username
- admin
- Password / access
- Password on the device label
Access: Web
Smart Hub
Source (opens in a new tab)ROUTER & MODEM REFERENCE
EE router & modem login
Login addresses, default credentials, and setup instructions for EE equipment.
Connect to the router’s Wi-Fi or Ethernet first. These links open a new tab on your device; the address may differ if the network was reconfigured.
QUICK START
Most likely login options
Start with the option that matches your model. Defaults apply to the factory state; use the password you chose if the device has already been set up.
Options are ordered by manufacturer documentation and coverage among the listed models. Hardware, firmware, and ISP versions can differ.
MODEL DETAILS
Login addresses & credentials
Passwords are case-sensitive. “Leave blank” means an empty field; “Not specified” means the source does not provide that detail. Entries without a model are brand-level references.
| Model / device | Login address | Username | Password / access | Notes & source |
|---|---|---|---|---|
| EESmart HubModem / gateway · Web | http://192.168.1.254 (opens in a new tab) | admin | Password on the device label | There is no admin/admin default. Each EE Smart Hub has a unique admin password printed on the card on the back of the hub, separate from the WiFi password. Recovery & reset instructionsTo log in: connect to the hub, browse to 192.168.1.254 and enter the admin password printed on the card on the back of the hub (this is different from the WiFi password, which is on the same card). To factory reset: with the hub on, press and hold the recessed Reset button on the back for about 20 seconds until it restarts; the network name, WiFi password and admin password revert to the values on the back card. |
| EESmart Hub PlusModem / gateway · Web | http://192.168.1.254 (opens in a new tab) | No username required | Password on the device label | EE's fibre gateway line (Smart Hub Plus / 6 Plus / 7 Plus) — distinct from the older EE Smart Hub already covered. The Hub Manager admin password is separate from the Wi-Fi password and is printed per-unit on the card on the back; login is at 192.168.1.254 with no username. EE: "That password is also on the card on the back of the hub." Recovery & reset instructionsType 192.168.1.254 in the browser address bar and press Enter, then log in with the admin password printed on the card on the back of the hub. A factory reset restores that printed admin password. |
No records match these filters. Try another model or clear the filters.
Related login addresses
GET CONNECTED
How to reach your router
- Connect your computer or phone to the router’s Wi-Fi or an Ethernet port.
- Open a documented login address. If it does not load, look for the Router or Default gateway address in your device’s network settings.
- Match your model and hardware revision to the table. Use the device label or your setup password when the model has no shared default.
Admin password or Wi-Fi password?
The admin password opens the router’s settings. The Wi-Fi password connects a device to the wireless network. They may be different, and an ISP or cloud account can be separate again.
If the password does not work
Check capitalization and the device label, then use the manufacturer’s password-recovery instructions. A factory reset erases settings and may require ISP setup details; follow the instructions for your exact model.
Find your model’s manual →Sources & data
Router default-credential data from ssid.ai (Drumworks Ventures FZ), licensed CC BY 4.0. Adapted, organized and supplemented by Manuals+. The data is provided as is; manufacturers and ISPs can change defaults.
Additional factual entries: Austin Songer’s credential list and Clint Milner’s credential list. Each table entry links to its supporting source. Updated 2026-10-16.