Default credentials
- Username
- admin
- Password / access
- 1234
Access: Web
BR-6428nS V5, BROADBAND ROUTER Rev. HARDWARE: REV A. BOOT CODE: 1.0 RUNTIME CODE 2.63
Source (opens in a new tab)ROUTER & MODEM REFERENCE
Edimax router & modem login
Login addresses, default credentials, and setup instructions for Edimax equipment.
Connect to the router’s Wi-Fi or Ethernet first. These links open a new tab on your device; the address may differ if the network was reconfigured.
QUICK START
Most likely login options
Start with the option that matches your model. Defaults apply to the factory state; use the password you chose if the device has already been set up.
Options are ordered by manufacturer documentation and coverage among the listed models. Hardware, firmware, and ISP versions can differ.
MODEL DETAILS
Login addresses & credentials
Passwords are case-sensitive. “Leave blank” means an empty field; “Not specified” means the source does not provide that detail. Entries without a model are brand-level references.
| Model / device | Login address | Username | Password / access | Notes & source |
|---|---|---|---|---|
| Edimax–Router · Not specified | – | guest | 1234 | Model not specified by this list. |
| Edimax–Router · Not specified | – | admin | Leave blank | Model not specified by this list. |
| Edimax–Router · Not specified | – | edimax | software01 | Model not specified by this list. for most Edimax HW???? |
| Edimax–Router · Not specified | – | admin | password | Model not specified by this list. |
| Edimax–Router · Not specified | – | admin | 1234 | Model not specified by this list. |
| Edimax–Router · Not specified | – | admin | 123 | Model not specified by this list. |
| Edimax–Router · Not specified | – | admin | epicrouter | Model not specified by this list. |
| Edimax–Router · Not specified | – | admin | su@psir | Model not specified by this list. |
| Edimax–Router · Not specified | – | guest | Leave blank | Model not specified by this list. |
| EdimaxBR-6428nS V5Router · Web | http://192.168.2.1 (opens in a new tab) | admin | 1234 | N300 (802.11b/g/n, 2.4GHz-only, up to 300 Mbps) entry-level Wi-Fi 4 router/AP/range-extender combo. Wired login at http://192.168.2.1; the official User Manual's Login section and the product-label default table both state a genuine static default of admin / 1234 (a later FAQ line inconsistently prints admin/admin — the label value governs). Recovery & reset instructionsPress and hold the WPS/Reset button on the back panel for at least 10 seconds until the power LED begins to flash, then release and wait for the router to restart; defaults return to admin / 1234 at http://192.168.2.1. |
| EdimaxBR-6473AX (AX3000)Router · Web | http://192.168.2.1 (opens in a new tab) | admin | Password on the device label | AX3000 dual-band Wi-Fi 6 smart router, configurable in AP or Router mode — a newer Wi-Fi 6 SKU above the already-seeded BR-6428NS V5 (static admin/1234). Official Edimax user manual: "Default User Name: admin" and a "unique 8 digits default Password" shown on the device sticker, with access via "the default IP 192.168.2.1 (In AP Mode)" — a device-unique label password, not a shared static default. Recovery & reset instructionsPress and hold the reset button for approximately 10 seconds until the device reboots to factory defaults; log in with username admin and the unique 8-digit password printed on the device sticker at 192.168.2.1 (AP mode). |
| EdimaxBROADBAND ROUTER Rev. HARDWARE: REV A. BOOT CODE: 1.0 RUNTIME CODE 2.63Router · HTTP | – | admin | 1234 | Defaults may depend on the listed model, revision, firmware or ISP. |
| EdimaxES-5224RXMRouter · MULTI | – | admin | 123 | Defaults may depend on the listed model, revision, firmware or ISP. |
| EdimaxEW-7205APL Rev. FIRMWARE RELEASE 2.40A-00Router · MULTI | – | guest | Leave blank | Defaults may depend on the listed model, revision, firmware or ISP. |
| EdimaxWIRELESS ADSL ROUTER Rev. AR-7024Modem / gateway · MULTI | – | admin | epicrouter | Defaults may depend on the listed model, revision, firmware or ISP. |
No records match these filters. Try another model or clear the filters.
Related login addresses
GET CONNECTED
How to reach your router
- Connect your computer or phone to the router’s Wi-Fi or an Ethernet port.
- Open a documented login address. If it does not load, look for the Router or Default gateway address in your device’s network settings.
- Match your model and hardware revision to the table. Use the device label or your setup password when the model has no shared default.
Admin password or Wi-Fi password?
The admin password opens the router’s settings. The Wi-Fi password connects a device to the wireless network. They may be different, and an ISP or cloud account can be separate again.
If the password does not work
Check capitalization and the device label, then use the manufacturer’s password-recovery instructions. A factory reset erases settings and may require ISP setup details; follow the instructions for your exact model.
Find your model’s manual →Sources & data
Router default-credential data from ssid.ai (Drumworks Ventures FZ), licensed CC BY 4.0. Adapted, organized and supplemented by Manuals+. The data is provided as is; manufacturers and ISPs can change defaults.
Additional factual entries: Austin Songer’s credential list and Clint Milner’s credential list. Each table entry links to its supporting source. Updated 2026-10-16.