ROUTER & MODEM REFERENCE

Bell router & modem login

Connect to the router’s Wi-Fi or Ethernet first. These links open a new tab on your device; the address may differ if the network was reconfigured.

QUICK START

Most likely login options

See every listed combination ↓

Start with the option that matches your model. Defaults apply to the factory state; use the password you chose if the device has already been set up.

Check the device label

Username: No username required
Password / access: Password on the device label

Access: Web

Bell Home Hub 4000, Giga Hub

Source (opens in a new tab)

Options are ordered by manufacturer documentation and coverage among the listed models. Hardware, firmware, and ISP versions can differ.

MODEL DETAILS

Login addresses & credentials

2 records

Passwords are case-sensitive. “Leave blank” means an empty field; “Not specified” means the source does not provide that detail. Entries without a model are brand-level references.

Models, login addresses, credentials, instructions and sources
Model / device	Login address	Username	Password / access	Notes & source
BellBell Home Hub 4000Modem / gateway · Web	http://bell.ca/mymodem (opens in a new tab)http://192.168.2.1 (opens in a new tab)	No username required	Password on the device label	Canadian fibre/FTTH gateway. Admin is reached at bell.ca/mymodem (when connected) or 192.168.2.1. There is no default username, and the default administrator password is the modem's own serial number printed on the sticker on the back of the unit — a unique per-device value, not a generic default. Manufacturer (opens in a new tab) Recovery & reset instructions Perform a factory reset (hold the reset button on the modem) to restore the default admin password, which is the serial number on the back-panel sticker. On-device, use the front up/down arrows to select Modem Management to view settings.
BellGiga HubModem / gateway · Web	http://bell.ca/mymodem (opens in a new tab)http://192.168.2.1 (opens in a new tab)	No username required	Password on the device label	Bell's tri-band Wi-Fi 6 fibre gateway (XGS-PON/GPON FTTH, supports Bell Home phone/VoIP). Admin login is password-only with no username field; the default password is the unit's serial number from the rear label — unique per device, not a shared static default. Distinct from the older Home Hub 4000. Manufacturer (opens in a new tab) Recovery & reset instructions Browse to bell.ca/mymodem (or 192.168.2.1) and log in with the administrator password, which by default is the serial number printed on the sticker on the back of the modem. To wipe a custom password, hold the recessed reset button on the back until the modem restarts.

Related login addresses

GET CONNECTED

How to reach your router

Connect your computer or phone to the router’s Wi-Fi or an Ethernet port.
Open a documented login address. If it does not load, look for the Router or Default gateway address in your device’s network settings.
Match your model and hardware revision to the table. Use the device label or your setup password when the model has no shared default.

Admin password or Wi-Fi password?

The admin password opens the router’s settings. The Wi-Fi password connects a device to the wireless network. They may be different, and an ISP or cloud account can be separate again.

If the password does not work

Check capitalization and the device label, then use the manufacturer’s password-recovery instructions. A factory reset erases settings and may require ISP setup details; follow the instructions for your exact model.

Find your model’s manual →

Sources & data

Router default-credential data from ssid.ai (Drumworks Ventures FZ), licensed CC BY 4.0. Adapted, organized and supplemented by Manuals+. The data is provided as is; manufacturers and ISPs can change defaults.

Additional factual entries: Austin Songer’s credential list and Clint Milner’s credential list. Each table entry links to its supporting source. Updated 2026-10-16.