Skip to content
Manuals+

ROUTER & MODEM REFERENCE

ARRIS router & modem login

Login addresses, default credentials, and setup instructions for ARRIS equipment.

Connect to the router’s Wi-Fi or Ethernet first. These links open a new tab on your device; the address may differ if the network was reconfigured.

QUICK START

Most likely login options

See every listed combination ↓

Start with the option that matches your model. Defaults apply to the factory state; use the password you chose if the device has already been set up.

1

Default credentials

Username
admin
Password / access
password

Access: Web

SURFboard SBG7600AC2, TG1652 (izzi México gateway), TG862 (izzi México gateway)

Source (opens in a new tab)
2

Check the device label

Username
admin
Password / access
Password on the device label

Access: Web

SURFboard S33, SURFboard SB8200, TG3442 (izzi México gateway)

Source (opens in a new tab)

Options are ordered by manufacturer documentation and coverage among the listed models. Hardware, firmware, and ISP versions can differ.

MODEL DETAILS

Login addresses & credentials

7 records

Passwords are case-sensitive. “Leave blank” means an empty field; “Not specified” means the source does not provide that detail. Entries without a model are brand-level references.

Models, login addresses, credentials, instructions and sources
Model / deviceLogin addressUsernamePassword / accessNotes & source
ARRIS–Router · Not specified–adminpassword

Model not specified by this list.

ARRISSURFboard S33Modem / gateway · Webhttp://192.168.100.1 (opens in a new tab)adminPassword on the device label

The password is derived from the device: username admin, password = last 8 digits of the serial number printed on the label, with a forced password change on first login. Some early firmware accepted admin/password. No universal factory default.

Recovery & reset instructions

Open a browser to http://192.168.100.1 to reach the S33 web manager (this is a cable-modem diagnostics/settings page, not a Wi-Fi router). Log in with username 'admin' and the last 8 digits of the serial number on the bottom label, then create a new password when prompted. If locked out, wait 10 minutes after too many failed attempts, or factory reset by holding the recessed Reset button on the back for about 10 seconds; after reset, log in again with admin + last 8 of the serial.

ARRISSURFboard SB8200Modem / gateway · Webhttp://192.168.100.1 (opens in a new tab)adminPassword on the device label

Modem, not a router. Older firmware shipped with admin/password, but current firmware uses admin plus the last 8 digits of the serial number (from the label) and forces you to create a new password on first login. There is no universal admin/admin.

Recovery & reset instructions

The SB8200 is a modem only (no Wi-Fi), so 192.168.100.1 is a diagnostics/web-manager page, not a router settings page. To reach it, open a browser to http://192.168.100.1. On current firmware the username is 'admin' and the password is the last 8 characters of the serial number printed on the modem's bottom label; you'll be prompted to set a new password on first login. To factory reset, press and hold the recessed Reset button on the back with a paperclip for about 10 seconds until the modem restarts, which reverts the admin password to the last-8-of-serial default.

ARRISSURFboard SBG7600AC2Modem / gateway · Webhttp://192.168.0.1 (opens in a new tab)adminpassword

Documented default is admin / password (case-sensitive); the web UI forces you to change username and password on first login.

Recovery & reset instructions

Hold the recessed reset button on the rear ~15 seconds until the modem restarts to restore factory defaults.

ARRISTG1652 (izzi México gateway)Modem / gateway · Webhttp://192.168.0.1 (opens in a new tab)adminpassword

ARRIS TG1652 DOCSIS cable gateway issued by izzi México, dual-band Wi-Fi with separately-shown 2.4GHz/5GHz network names — a genuine static default, unlike several label-based izzi siblings. izzi's official credentials page has a dedicated section for this model: "en el apartado User Name, ingresa la palabra admin" and "En el apartado Password, deberás ingresar la palabra password (recuerda ingresar en minúsculas tanto admin como password)."

Recovery & reset instructions

A short press-and-release of the reset button restarts the modem without changes; press and hold for 30 seconds to restore factory settings.

ARRISTG3442 (izzi México gateway)Modem / gateway · Webhttp://192.168.0.1 (opens in a new tab)adminPassword on the device label

ARRIS TG3442 DOCSIS cable gateway, dual-band 2.4/5GHz Wi-Fi, 4x Gigabit Ethernet, 2 telephone ports. izzi's official credentials page: "en el apartado Username, ingresa la palabra admin... En el apartado Password, deberás ingresar la contraseña tal como aparece en la etiqueta de tu módem."

Recovery & reset instructions

A short press-and-release of the reset button restarts the modem without changes; press and hold for 30 seconds to restore factory settings.

ARRISTG862 (izzi México gateway)Modem / gateway · Webhttp://192.168.0.1 (opens in a new tab)adminpassword

Legacy DOCSIS 3.0 cable gateway, single 2.4GHz Wi-Fi band, 4x Ethernet ports — a genuine static default (unlike the label-based izzi siblings). izzi's official credentials page: "en el apartado User Name, ingresa la palabra admin... En el apartado Password, deberás ingresar la palabra password."

Recovery & reset instructions

A short press-and-release of the reset button restarts the modem without changes; press and hold for 30 seconds to restore factory settings.

Related login addresses

GET CONNECTED

How to reach your router

  1. Connect your computer or phone to the router’s Wi-Fi or an Ethernet port.
  2. Open a documented login address. If it does not load, look for the Router or Default gateway address in your device’s network settings.
  3. Match your model and hardware revision to the table. Use the device label or your setup password when the model has no shared default.

Admin password or Wi-Fi password?

The admin password opens the router’s settings. The Wi-Fi password connects a device to the wireless network. They may be different, and an ISP or cloud account can be separate again.

If the password does not work

Check capitalization and the device label, then use the manufacturer’s password-recovery instructions. A factory reset erases settings and may require ISP setup details; follow the instructions for your exact model.

Find your model’s manual →

Sources & data

Router default-credential data from ssid.ai (Drumworks Ventures FZ), licensed CC BY 4.0. Adapted, organized and supplemented by Manuals+. The data is provided as is; manufacturers and ISPs can change defaults.

Additional factual entries: Austin Songer’s credential list and Clint Milner’s credential list. Each table entry links to its supporting source. Updated 2026-10-16.