Logic Concept DART-PRO-ARGB Computer Case

Features

1. Left Side Panel
2. PSU Dust Filter
3. Toolless Retention Bracket
4. Top Dust Filter
5. SSD Tray
6. Right Side Panel
7. HDD/SSD cage

Accessory Kit

1. Motherboard screws
2. HDD screws
3. PSU screws
4. Standoffs
5. Screws for installing fans on the PSU shroud
6. Cable ties

Panel

Specification

PC case dimensions

PC: 385 x 200 x 456 mm (L x W x H)

Installing 3 x 140 mm fans on the front of the case is possible only from the inside of the case.

Removing side panels

Installing motherboard

Installing 3.5″ HDDs

Installing 2.5″ SSDs

Installing the GPU

Installing the Power Supply

Installation of ARGB hub

If your motherboard comes with ARGB support:

1. Connect (A) to the motherboard’s PWM socket
2. Connect (B) to the motherboard’s Addressable RGB (5V) socket If your motherboard doesn’t support ARGB:
   • Connect (A) to the motherboard’s PWM socket.
   • Connect the 2-pin reset switch connector (D) with your hub.
   • Connect (C) to the PSU’s SATA connector.
   • Use the RGB fan connectors (E) to connect the Addressable RGB fans with your hub.

Quick start guide/installation:

1. Open the housing.
2. Install all computer components following the instructions in the indi­vidual assembly instructions for each component.
3. Mount in the housing and connect the power supply to the required com­ponents, following the installation instructions of the power supply and the instructions of the components that require its connection. The power supply is mounted in a tunnel, in the lower part of the case, with the fan facing outside the case (down).
4. Check the correct assembly of components and the connection of power plugs.
5. Close the housing.
6. Connect the monitor, keyboard, and other accessories to the computer.
7. Connect the power cord to the socket in the power supply and the 230V mains socket.
8. Set the power switch on the PSU housing to the I position (if present).

This device was designed and U made of high-quality reusable materials and components. If the de­vice, its packaging, user’s manual, etc. are marked with crossed waste containers, it means they are subject to segregated household waste col­lection in compliance with the Direc­tive 2012/19/UE of the European Parliament and the Council.

• This marking informs that electric and electronic equipment shall not be thrown away together with house­hold waste after it’s been utilized. The user is obliged to bring the uti­lised equipment to the electric and elec­tronic waste collection point. Those running such collection points, in­cluding local collection points, shops, or commune units, provide a conven­ient system enabling to scrapping of such equipment.
• Appropriate waste man­agement aids in avoiding conse­quences that are harmful to peo­ple and ethe nvironment and result from dangerous materials used in the de­vice, as well as improper storage and processing. Segregated household waste collection aids recycle materi­als and components of which the de­vice was made.
• A household plays a crucial role in contributing to recy­cling and reusing the waste equip­ment. This is the stage where the basics are shaped which largely in­fluence the environment being our common good. Households are also one of the biggest users of small electrical equipment.
• Reasonable management at this stage aids and favors recycling. In the case of im­proper waste management, fixed penalties may be imposed in accord­ance with national legal regulations.

Documents / Resources

Logic Concept DART-PRO-ARGB Computer Case [pdf] Owner's Manual DART-PRO-ARGB-MIDI, DART-PRO-ARGB Computer Case, DART-PRO-ARGB, Computer Case, Case

References

• User Manual