Linear Gate Openers CSI724 Gate Hinges
Specifications
- Product Name: GUARDIAN Gate Hinges Weld On
- Mounting: Yoke welded to gate, channel welded to post
- Maintenance: Grease zerk for lubrication
- Manufacturer: Guardian Gate Hardware
Product Usage Instructions
Installation
- Mount the yoke (FIG. 1) to the gate by welding.
- Weld the channel to the post.
- Ensure hinge pins are in a straight line during installation.
- Do not weld the top and bottom of the hinges.
- For hinge capacities, refer to sales literature or contact Guardian Gate Hardware for technical support.
Maintenance
A regular maintenance schedule is crucial for the effectiveness and longevity of the gate system:
- Use a high-quality, multi-purpose grease for lubrication.
- Apply one pump of grease through the grease zerk (FIG 3) every 3 months under normal conditions.
- For severe operating conditions, increase the frequency of maintenance.
- Avoid over-lubrication as it can cause issues.
INSTALLATION:
- GUARDIAN gate hinges are to be mounted with the yoke (FIG. 1) welded to the gate and the channel welded to the post.
- The hinges must be installed with the hinge pins in a straight line.
- Reference sales literature for hinge capacities or contact Guardian Gate Hardware for technical support.
- Weld only on the vertical portions of the yoke and plate.
- DO NOT weld the top and bottom of the hinges. Bolt on versions of this hinge are available.
MAINTENANCE:
- A regular maintenance schedule is important for the efficacy and durability of any gate system. This GUARDIAN gate hinge is equipped with a grease zerk (FIG 3) for easy lubrication. One pump of a high quality, multi purpose grease every 3 months should be sufficient under normal operating conditions. More frequent maintenance is necessary under severe operating conditions. Do not over lubricate.
- www.LinearGateOpeners.com | 800-878-7829 | Sales@LinearGateOpeners.com
FAQs
Q: How often should I lubricate the GUARDIAN gate hinge?
A: For normal operating conditions, apply one pump of grease every 3 months. Increase frequency for severe conditions.
Q: Can I weld the top and bottom of the hinges during installation?
A: No, only weld on the vertical portions of the yoke and plate. Avoid welding the top and bottom of the hinges.
Documents / Resources
 |
Linear Gate Openers CSI724 Gate Hinges [pdf] Installation Guide CSI724 Gate Hinges, CSI724, Gate Hinges, Hinges |