Libratone TOO User Manual
App Download
* Or search ‘Libratone’ in Apple App Store or Google Play to download App
① Power Button ② Touch Interface ③ Status Indicator Lights
Long press to power on/off
Tap the power button to check battery level when the speaker is turned on
Touch Interface
Playback and talk control via the touch interface
① Charging Port ② Line-in ③ ChargingIndicator Light
Charging Port
The charging light breathes when charging and is solid on when fully charged
Line-in
Music playback from Bluetooth will be stopped when the audio cable is plugged in
Bluetooth Connection
1. Power on
Long press the power button until the Nightingale is lit
2. Enter Bluetooth Pairing Mode
The speaker will enter Bluetooth pairing mode automatically during the first run, this is indicated by a side-to-side sequence on the top
*Press the Nightingale for 2 seconds to enter Bluetooth pairing mode
3. Select Libratone Speaker
Find and select your LIBRATONE TOO in the Bluetooth device list of your phone
4. Connected
The lights will blink twice when connected. The speaker is ready to play!
Basic Operation
Volume Control
Rotate your finger clockwise or counterclockwise along the touch interface to adjust volume
Playback and talk control
Short press the Nightingale for music play/pause
Long press to enter/exit Bluetooth pairing mode
Long press to reject a call
Double click to next song
Status Indication
The Nightingale
Lit at 100% when playing
Lit at 50% when paused
Breathing when no connection
Blinking when incoming call/Plus 1 setup
Bottom Light
Continuous blinking when low battery
Triple blinking when battery is too low to be powered on
Plus 1
Plus 1 Setup
Enter the speaker page in App, click ‘PLUS 1’ icon at the bottom, follow the instruction to complete the connection
You can play music synchronously on the two connected speakers
FAQ
Playback is interrupted or has noise?
Normally, the working distance is 10m at a non-sheltered area. If the distance to the playing device is more than 10m the music playback will be interrupted
The speaker cannot connect to an already paired device
If you can’t connect, please delete the speaker from the Bluetooth device list in the phone, press the Nightingale for 2 seconds to enter Bluetooth pairing mode and then pair with the phone again
I have two phones, and I want to connect them to the same speaker
If the speaker have been previously paired with the two phones, just select the speaker from the Bluetooth device list in the phone to connect
Why does the speaker automatically turn off if there are no playback detected?
Without power supply, the speaker will automatically power off if no operation/playback is detected within 15 minutes to save power
* Phone, tablet computer or any other device with Bluetooth are all applicable
This User Manual takes phone as an example for operation instruction
Product specification
| Product Name | LIBRATONE TOO |
|---|---|
| Product Model | LTG200 |
| Channel | 2.0 |
| Speaker | 2 * 1.5″ full range tweeter 1 * 2.3″ passive radiator |
| Max. Power | 30W |
| S/N Ratio | 95dBA |
| Max. SPL | 90dBA@1m |
| Frequency Response Range | 70~18kHz |
| Audio Input | Bluetooth, line-in |
| Playing Time | 12hours |
| Charging Time | <4h1.5A |
| Product Dimension | 207*61.5*59mm |
| Weight | 580g |
