Y17 AB Remote Shutter
Product Information
Specifications
- Compatibility: iOS 6.0 and above, Android 4.2 and above
- Bluetooth Version: 4.0
- Color: Black
- Power Source: CR2032 Button Cell Battery
Product Usage Instructions
Pairing the Remote with Your Device
- Turn on the switch located on the right side of the remote. The
blue light will start flashing. - Access the Bluetooth settings on your phone.
- Initiate a search for devices via Bluetooth until “AB Shutter
3” is detected. - Select and connect to “AB Shutter 3” until the connection is
successful. - Open the camera app on your phone and press the button on the
remote to capture photos.
Using the Remote
The remote is designed to work seamlessly with your smartphone
camera. Pressing the button on the remote will trigger the camera
shutter, allowing you to take photos without physically touching
your phone.
FCC Warning
For regulatory compliance, please adhere to FCC guidelines while
using this product.
FAQ
Q: Can I use this remote with a tablet?
A: The remote is optimized for smartphones but may work with
tablets that support Bluetooth connectivity.
Q: How do I replace the battery in the remote?
A: To replace the battery, open the battery compartment on the
back of the remote and carefully swap out the old CR2032 button
cell battery with a new one.
User Manual
1. How to pair the Remote with your device? Step 1: Turn on switch on the right side and the blue light will flash. Step 2: Click phone settings and enter into Bluetooth. Step 3: Start to search devices by Bluetooth until “AB shutter 3” is found. Step 4: Connect to AB shutter 3 until it is connected successfully. Step 5: Open the camera on your phone and press the button on the Remote to take photos.
2. Compatibility Work with devices with IOS 6.0 and above, Android 4.2 and above.
3. FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Documents / Resources
 |
LiangYu Y17 AB Remote Shutter [pdf] User Manual Y17, Y17 AB Remote Shutter, AB Remote Shutter, Remote Shutter, Shutter |