LEXCO - logoLED Batten
(Compatible with DALI)LEXCO Bat Series LED Batten -LEXCO Bat Series LED Batten - icon

Bat Series LED Batten

IMPORTANT – These instructions are for your safety. Please read through them thoroughly prior to handling the product and retain them for future reference.

Bat-4ft-DA
5059340964485
Bat-5ft-DA
5059340964126
Bat-6ft-DA
5059340964546
V20824_5059340964485_MAND2_2324

Parts

LEXCO Bat Series LED Batten - Parts

You will need

LEXCO Bat Series LED Batten - You will need

Care & maintenance

LEXCO Bat Series LED Batten - Care & maintenance

Safety

  • These instructions are for your safety. Please read through them thoroughly prior to installation and retain them for future reference.
  • All fittings must be installed by a competent person in accordance with local regulations (IET wiring regulation BS7671).
  • Check the pack and make sure you have all of the parts listed.
  • Remove all packaging, wrap etc from the product.
  • Decide on the appropriate location for your product.
  • This product is suitable for indoor use only and not for areas constantly subject to moisture such as bathroom.
  • CAUTION: IP65 is guaranteed when the product is properly installed and sealed.
  • Always avoid the product to be located at corrosive environment.
  • USE ROUND CABLE ONLY
  • Ensure the connection is tightened, to create a good water seal
  • The round main cable should be at least 7 mm in diameter.
  • Never use the terminal cables to bear the product weight.
  • The product must be securely fixed to the mounting surface using the anchor bolts supplied. The anchor bolts supplied are suitable for masonry or concrete only. Other fixings not supplied and must be purchased.
  • Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
  • IMPORTANT: The fixing point(s) selected must be capable of supporting the full weight of the light fitting.
  • Wiring diagram is for reference only. Always refer to the terminal marking for wiring. Ensure that all electrical connections are tight and that no loose strands are left out of the terminal block.
  • Never put anything on the product or hang anything on any part of this product.
  • When the product does not light after installation:
    > Ensure there is no electricity failure
    > Ensure all the connections are secured
  • If you have any doubt about installation/use of this product, consult a qualified electrician.
  • Always disconnect the product from mains at least 10 minutes allowing to cool down before any maintenance or adjustment.
  • It is recommended to have a regular schedule of care and maintenance to keep the surface condition well.

Technical Data

Supply voltage:

220-240 V—, 50 Hz

Bulb Type:

5059340964485: LED (36W) 5059340964126: LED (55W) 5059340964546: LED (70W)
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
Do not stare at the operating light source.
CE SYMBOL This product complies with conformity requirements of the applicable European Regulations or Directives.
Uk CA Symbol This product complies with conformity requirements of the applicable UK Regulations.

Control gear:

Replaceable control gear by a professional

Energy efficiency class:

This product contains a light source of energy efficiency class <D>
LEXCO Bat Series LED Batten - icon1 Class I product, must be connected to earth

IP65

Jet-proof
WEE-Disposal-icon.png Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
FOAMit FI-BP-10N Battery Powered Foam Unit - Symbol 6 Caution! Risk of electric shock!

xxWyy

xx-year; yy-week of the year.

Guarantee

We take special care to select high quality materials and use manufacturing techniques that allow us to create products incorporating design and durability.
This product has a manufacturer’s guarantee of 7 years against manufacturing defects, from the date of purchase (if bought in store) or date of delivery (if bought online), at no additional cost for normal use.
To make a claim under this guarantee, you must present your proof of purchase (such as a sales receipt, purchase invoice or other evidence admissible under applicable law), please keep your proof of purchase in a safe place. For this guarantee to apply, the product you purchased must be new, it will not apply to second hand or display products. Unless stated otherwise by applicable law, any replacement product issued under this guarantee will only be guaranteed until expiry of the original period guarantee period.
This guarantee covers product failures and malfunctions provided the product was used for the purpose for which it is intended and subject to installation, cleaning, care and maintenance in accordance with the information contained in these terms and conditions, in the user manual and standard practice, provided that standard practice does not conflict with the user manual.
This guarantee does not cover defects and damage caused by normal wear and tear or damage that could be the result of improper use, faulty installation or assembly, neglect, accident, misuse, or modification of the product. Unless stated otherwise by applicable law, this guarantee will not cover, in any case, ancillary costs (shipping, movement, costs of uninstalling and reinstalling, labour etc), or direct and indirect damage.
If the product is defective, we will replace or refund, within a reasonable time.
Rights under this guarantee are enforceable in the country in which you purchased this product.
Guarantee related queries should be addressed to the store you purchased this product from.
The guarantee is in addition to and does not affect your statutory rights.

LEXCO Bat Series LED Batten - Installation

LEXCO Bat Series LED Batten - Side Entry

LEXCO Bat Series LED Batten - Installation1

Wiring Diagram

LEXCO Bat Series LED Batten - LED Batten

LEXCO Bat Series LED Batten - Sensor

LEXCO Bat Series LED Batten - LED Batten Kit

LEXCO Bat Series LED Batten - Emergency Kit

Manufacturer:
UK Manufacturer:
Kingfisher International Products Limited,
1 Paddington Square, London, W2 1GG,
United Kingdom
EU Manufacturer:
Kingfisher International Products B.V.,
Rapenburgerstraat 175E,
1011 VM Amsterdam,
The Netherlands
EN www.diy.com
www.screwfix.com
www.screwfix.ie
To view instruction manuals online, visit www.kingfisher.com/products
Made in China

5059340964485_MNL_IN_V04.indd
8/2/2024 11:56:07 AM

Documents / Resources

LEXCO Bat Series LED Batten [pdf] Instruction Manual
5059340964485, 5059340964126, 5059340964546, Bat Series LED Batten, Bat Series, LED Batten, Batten

References

Leave a comment

Your email address will not be published. Required fields are marked *