LEVER Smart Scale User Guide

LEVER Smart Scale

Specifications

• Founded: 2019
• Founders: Brad and Ryan
• Purpose: Body weight support for athletes
• Scale Installation: Front bar only
• Scale On/Off: Button on front, red blinking light indicates on
• Connectivity: Bluetooth via LEVER App
• Weight Adjustment: Up to 45 lbs (maximum)

About Us

LEVER was founded in 2019 by two competitive athletes in Boulder, Colorado. Cofounders Brad andRyan believe that body weight support should be an essential element in every competitive athlete’s training to minimize, prevent, and heal from injury as well as continually perform at one’s best.

User Warnings

• Do not tighten the bungee or reduce weight while the treadmill is in motion.
• Do not use if any parts are damaged or destroyed.
• Do not tighten past 45 Ibs Only use with compatible treadmills.
• Read the manual

Get the full experience and access by downloading our application.

Installing Scale

1. It is important to install the scale onto the front bar and not the back bar. The on button of the scale should face the same direction as the connector on the front bar
2. Slide the scale through the bar and push it through the bend section of the front bar. For some LEVER models, this will be easier than others.
3. Position the scale to the desired placement to mirror the right cube.
4. To secure the scale on the front bar, tighten the screws with the allen key.

Using Scale & App

1. To turn on the smart scale, press the button on the front. When the scale is on, a red light will blink.
2. To connect with the scale, open the LEVER app and connect via bluetooth.
3. Once it’s connected, make sure the scale is zeroed out, and there is no tension on the bungee. Proceed to adjust the bungee to the desired weight.
4. Press Start on the screen to begin your run.
5. The weight can be adjusted mid-run by stepping off the belt. By clicking the circle below “weight off”, select “adjust weight” and set the desired weight, and press “save”.
6. Your scale will automatically shut off after you have finished your run and saved your session.

Troubleshooting

• Scale not turning on: Ensure the button on the front of the scale is pressed firmly. Check for a blinking red light.
• Cannot connect via Bluetooth: Make sure the scale is turned on, and the LEVER app is open. Ensure Bluetooth is enabled on your device.
• Inaccurate weight readings: Ensure the scale is zeroed out before starting your workout and that there is no tension on the bungee.
• Scale not securing properly: Double-check that you are using the correct Allen key sizes (3 mm for the scale, 2 mm for other parts) and that all screws are tightened.

FAQs

• Where can I download the LEVER app?
  • You can download the LEVER app from your device’s app store. Look for ‘Download Now’ links or search for ‘LEVER Movement’.
• What is the maximum weight adjustment?
  • Do not tighten past 45 lbs.
• Can I adjust the weight while the treadmill is in motion?
  • No, you must step off the treadmill belt to adjust the weight mid-run.
• What should I do if a part is damaged?
  • Do not use the product if any parts are damaged or destroyed.
• Is the scale installed on the front or back bar?
  • It is important to install the scale onto the front bar and not the back bar.