LEDVANCE Contact Sensor 

CONTACT SENSOR


Sensor alignment

SMART+ WIFI INSTALLATION




https://www.ledvance.com/consumer/smart/faq/

LED behavior
Continuous blinking red Scanning for network
Red will be off Network joined
Solid red (3 seconds Power on
Solid blue Battery is charging
Blue will be of Battery is fully charged

Hereby, LEDVANCE GmbH declares that the radio equipment type LEDVANCE SMART+ Device is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: smartplus.ledvance.com/declaration-of-conformity. Wireless radio used in WIFI lamps/ luminaires /components 2412–2484 MHz, max. RF output power 16dBm. Wireless radio used in Bluetooth lamps/ luminaires /components 2402–2480 MHz, max. RF output power 9.5dBm

Points de collected sur www.quefairedemesdechets.fr

LEDVANCE GmbH
Steinerne Furt 62
86167 Augsburg, Germany
www.ledvance.com

Documents / Resources

LEDVANCE Contact Sensor [pdf] User Guide
Contact Sensor, Sensor

References

Leave a comment

Your email address will not be published. Required fields are marked *