Please read these installation instructions carefully before installing this product and keep them for future reference.
Safety instructionsOperate the product only when it is working properly.
In the event of a fault, do not touch the product.
Immediately turn off the product at an external switch. In the event of contact or continued operation in the event of a fault, there is a danger to life due to burns, electric shock or fire.
This is how you detect an error: the product does not work properly (e.g. cannot be switched on) the product smokes, crackles or smells burnt the product overheats (discoloration, also on adjacent surfaces)
Do not operate the product again until it has been repaired and checked exclusively by an authorized electrician!
Intended use
The product may:
- only be operated with a voltage of 230V ~50Hz.
- only be connected according to protection class II (two).
- only be used in accordance with protection class IP20.
- only be operated firmly mounted and on stable, level ground.
- not be subjected to strong mechanical stresses.
- not be changed or modified.
- not be operated with an external dimmer
- Operate only with E27 bulbs with a maximum load of 60 watts
The product is not intended for operation by children. Ensure that children do not come to any harm with the product, e.g. by being burned on hot surfaces or by electric shock. If the product is not used as intended, especially if moisture enters the product, there is a danger to life from burns, electric shock or fire.
Maintenance & care
The following environmental influences may have undesirable effects on the surface of the product:
- high salt content in the air
- Detergent
- other chemical substances (e.g. mold remover)
Protect the product by taking appropriate measures to avoid changes to the surface.
First disconnect the entire product from the power supply and allow it to cool down before carrying out any cleaning or maintenance workon the product. Clean the product regularly – only with a slightly damp, soft and lint-free cloth.
Storage
The product must be stored in a dry place, protected from contamination and mechanical stress.
After damp or dirty storage, the product may only be operated after a condition check by an authorized electrician.
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach
Tel. +49 (0) 2161 – 5 75 99 76
Documents / Resources
 |
ledscom SS-370 Socket With Cable [pdf] Instruction Manual SS-370 Socket With Cable, SS-370, Socket With Cable, With Cable |