ledscom de LC-L-316 Clamp Light
Product Information
Specifications:
- Model: LC-L-316
- Voltage: 230V ~50Hz
- Protection Class: II (two)
- Protection Class: IP20
- Bulb Type: E27, max 60 watts
Product Usage Instructions
Safety Instructions:
Operate the product only when it is working properly. In case of a fault, follow these steps:
- Do not touch the product.
- Turn off the product at an external switch.
- If the product does not work properly, smokes, overheats, or smells burnt, do not operate it until repaired by an authorized electrician.
Intended Use:
Ensure the following for safe and effective use:
- Operate at 230V ~50Hz.
- Connect according to Protection Class II (two).
- Use in accordance with Protection Class IP20.
- Operate firmly mounted on stable ground.
- Avoid strong mechanical stresses and do not modify the product.
- Operate only with E27 bulbs up to 60 watts.
Maintenance & Care:
Protect the product from environmental influences like high salt content and cleaning chemicals. Follow these maintenance steps:
- Disconnect from power before cleaning.
- Clean regularly with a slightly damp, lint-free cloth.
Storage:
Store the product in a dry place, protected from contamination and mechanical stress. After damp or dirty storage, have it checked by an authorized electrician before use.
Please read these installation instructions carefully before installing this product and keep them for future reference.
SAFETY INSTRUCTIONS
safety instructions Operate the product only when it is working properly.
In the event of a fault, do not touch the product.
Immediately turn off the product at an external switch. In the event of contact or continued operation in the event of a fault, there is a danger to life due to burns, electric shock or fire.
This is how you detect an error: the product does not work properly (e.g. cannot be switched on) the product smokes, crackles or smells burnt the product overheats (discoloration, also on adjacent surfaces)
Do not operate the product again until it has been repaired and checked exclusively by an authorized electrician!
Intended use
Please ensure that the product is only installed within its intended application (clamp light, reading light) to ensure safe and effective use.
The product may:
- only be operated with a voltage of 230V ~50Hz.
- only be connected according to protection class II (two).
- only be used in accordance with protection class IP20.
- only be operated firmly mounted and on stable, level ground.
- not be subjected to strong mechanical stresses.
- not be changed or modified.
- not be operated with an external dimmer Operate only with E27 bulbs with a maximum load of 60 watts
The product is not intended for operation by children. Ensure that children do not come to any harm with the product, e.g. by being burned on hot surfaces or by electric shock. If the product is not used as intended, especially if moisture enters the product, there is a danger to life from burns, electric shock or fire.
Maintenance & care
The following environmental influences may have undesirable effects on the surface of the product: high salt content in the air Detergent
- high salt content in the air
- Detergent
- other chemical substances (e.g. mold remover)
Protect the product by taking appropriate measures to avoid changes to the surface.
First disconnect the entire product from the power supply and allow it to cool down before carrying out any cleaning or maintenance work on the product.
Clean the product regularly – only with a slightly damp, soft and lint-free cloth.
Storage
The product must be stored in a dry place,protected from contamination and mechanical stress.
After damp or dirty storage, the product may only be operated after a condition check by an authorized electrician
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, Tel. +49 (0) 2161 – 5 75 99 76
Frequently Asked Questions
Q: Can children operate this product?
A: No, the product is not intended for operation by children.
Ensure children do not come in contact with hot surfaces or risk of electric shock.
Q: Can I use an external dimmer with this product?
A: No, do not operate the product with an external dimmer.
Documents / Resources
 |
ledscom de LC-L-316 Clamp Light [pdf] Instruction Manual LC-L-316, LC-L-316 Clamp Light, Clamp Light |