LEDOLUX-logo

LEDOLUX ORBIT LED Lamp

LEDOLUX-ORBIT-LED-Lamp-product

PRODUCT OVERVIEW

LEDOLUX-ORBIT-LED-Lamp-fig-1LEDOLUX-ORBIT-LED-Lamp-fig-2

NOTE

  • The terminal block is not supplied. Installation must be performed by a qualified person. In case of doubts as to the installation or use of the LED luminaire, consult the manufacturer.
  • Replace the luminaire after a failure. Self-repair shall void the warranty.
  • This product contains a light source with energy efficiency class A.
  • Keep the luminaire in a cool, dry, and clean environment. Keep away from water and fire
  • Make sure you disconnect the power supply before installation. Turn on the power after connecting and securing all luminaires in the circuit.
  • The light source used in this luminaire should only be replaced by the manufacturer or their service representative, or a similarly qualified person
  • Protect your eyes, and avoid looking at the light for a long period of time.
  • Dirtiness that settles down on the luminaire due to normal operation shall be cleaned with a damp cloth.
  • Do not use invasive cleaners or cleaning methods.

APPLICATION

LEDOLUX-ORBIT-LED-Lamp-fig-3

  • Industrial facilities
  • Warehouses
  • Technical rooms
  • Sport facilities

Ledolux Poland Sp. z o.o.
E-mail: info@ledolux.pl
Tel: +48 696 966 622
Data: 12.12.2022
We reserve the right to make design changes to luminaires.

Make sure you disconnect the power supply before installation

LEDOLUX-ORBIT-LED-Lamp-fig-4

  1. Fix the mounting bracket to the luminaire (hook M10, 10Nm).LEDOLUX-ORBIT-LED-Lamp-fig-5
  2. Drill a hole in the ceiling and install the hook.LEDOLUX-ORBIT-LED-Lamp-fig-6
  3. Hang luminaireLEDOLUX-ORBIT-LED-Lamp-fig-7
  4. Connect the luminaire according to the wire markings.LEDOLUX-ORBIT-LED-Lamp-fig-8
  5. Keep it watertight while connecting it.LEDOLUX-ORBIT-LED-Lamp-fig-9
  6. Drill a hole in the ceiling, install screws.LEDOLUX-ORBIT-LED-Lamp-fig-10
  7. Fix the mounting bracket to the luminaire using a hex wrench (4mm, 3Nm). Adjust the angle of tilt of the luminaire and lock the holder with a hex key (6mm, 5Nm). Attach the luminaire to the wall/ construction.
  8. Connect the luminaire according to the wire markings. Keep it watertight while connecting itLEDOLUX-ORBIT-LED-Lamp-fig-11

NOT INCLUDED

Connecting the power cable

LEDOLUX-ORBIT-LED-Lamp-fig-12

Connecting the dimming cable

LEDOLUX-ORBIT-LED-Lamp-fig-13

When no dimming, secure dimming cables – separate and isolate each one.

Documents / Resources

LEDOLUX ORBIT LED Lamp [pdf] Instruction Manual
ORBIT, ORBIT LED Lamp, LED Lamp, Lamp

References

Leave a comment

Your email address will not be published. Required fields are marked *