LEDCTRL FXN FXP Tuneable White Flexible Panel
Installation
The product
Accessories and Tools
Installation Steps
Note
“+” connect to white and red wire.
The above diagram is only for installation,not the physical drawing-
Attentions before installation
- Before installation, check that the product parameters are consistent with the requirements (Seeing product specifications or product labels)
- Load voltage, current, power, and power supply should be matched with the product.
- Follow the instructions of wiring diagram (first connect the load and then the power supply) to avoid short circuit.
- Make sure the correct connection of positive and negative poles between products and power supply. Otherwise, the light will not be on.
- Make sure the power cord firmly screwed into the terminal and it should not be pulled out by hands.
- The terminal should have insulation, waterproof and anti-corrosive treatment.
Common Faults and Troubleshoots
| Quick Guide | ||
| Problems | Reasons | Solutions |
| All LEDs can not light on. | No electric supply. | Power on |
| Automatic power protection from the open or short circuit in output of the power supply. | Fix the short circuit problem. | |
| Wrong connection of power supply. | ||
| LEDs can not light on partly. | Some switching mode power supplies are not powered. | Check the power supply system to fix it. |
| Power supply line error. | ||
| Mistaken wire connection of some products | Correctly connection | |
| Brightness of LED is inconsistent or insufficient. | Power overloaded. | Replace with more powerful power |
| Power supply circuit excessive consumption. | Make sure the working voltage of the product within ±5% of standard voltage, or keep balance by circuit power consumption. | |
| Excessive quantities in series connection of the product | Reduce the quantities of the product in series connection to meet requirement. | |
| LED flicker. | Connection point fault. | Remove bad connection point. |
| Switching power supply failure. | Replace a new power supply. | |
| Wrong Installation or use of products | Please follow the instructions. | |
WARNINR
- Do not disassemble or retrofit the light. Do not touch the surface of the light with a sharp object.
- Do not do live-line working during installation, especially for high-voltage product.
- Do not use any organic chemicals solvents.
- Use neutral glass adhesive to fix this product and it needs to be dried 4 hours in the open environment after operation.
- Treat the ends and the circuit connection points that are not connected to the main line with insulation, waterproof, and anti-corrosion in the installation.
- Use 18AWG (0-75mm^2 cross-sectional area) or thicker core wire to avoid adverse consequences caused by overheating, if the power cable need to lengthen.
- Make sure the input voltage meets the requirements and lines are connected correctly before lighting on.
- This product is for signage, and do not use as general lighting.
- Series connection with the max run.
- The length of the power cable between the power supply and the LED strip should not exceed 2 meters. Otherwise, large circuit loss will lead to inconsistent brightness.
- Installation, maintenance and repair should be operated by a qualified technician.
Statements and Recycling
Statements
- Repair should be operated by a qualified technician, if the external circuit or main line of this product is damaged.
- The parameters given in this manual are typical values and for reference only,
- All illustrations and drawings in this manual are for reference.
- This groduct is subject to change without notice.
Recycling
LED lighting products belongs to electronic products, please do recycling treatment according directives.
Instruction of single-sided lightbox
Dimission
LED CTRL, 1/483 BALMAIN
WWW.LEDCTRL.COM
LILYFIELD, NSW 2040, AUSTRALIA
Documents / Resources
 |
LEDCTRL FXN FXP Tuneable White Flexible Panel [pdf] Installation Guide FXN FXP Tuneable White Flexible Panel, FXN, FXP Tuneable White Flexible Panel, Tuneable White Flexible Panel, Flexible Panel |