Embedded in your success, Embedded in your better life
World-leading provider of embedded/loT products and solutions
G202 Industrial Edge Computing Gateway
Quick Installation Guide
Version: 1.1
© Vantron Technology, Inc. All rights reserved.
COMPONENT CHECKLIST
Check if all components are available:
- Gateway
- 6G LTE antenna / Wi-Fi & EIT antenna
- Power adapter
- Power cable
- DIN rail mount bracket
wall mount bracket
Note: Actual accessories might vary slightly from the list above as the customer order might differ from the standard configuration options.
INSTALL THE GATEWAY
(DIN rail mount for Illustration)
- Hold the gateway vertically;
- Place the gateway on a fixed DIN rail and fit the clamp of the bracket (the spring inside) into one side of the DIN rail;
- Push the gateway in such a way as to compress the spring till there is enough space for the latch of the bracket (non-spring side) to fit the other side of the DIN rail properly.
Note: The DIN rail mount bracket is pre-installed on the gateway before shipment.
INSTALL THE ANTENNAS
- Install the round head antennas to the WLAN antenna connectors;
- Install the flat head antennas to the LTE antenna connectors;
- Tighten the rotating heads to secure the antennas in proper position.
INSTALL THE SIM CARD
- Insert an activated SIM and into SMI1 slot with the gold-colored contacts facing down, or, insert into SIM2 slot with the gold-colored contacts facing up;
- Push the SIM card to secure it.
Note: Installing the Micro SD card is literally the same as installing the SIM card, and users need only to install the Micro SD card into corresponding slot with the gold-colored pins facing up.
ETHERNET CONNECTION
There are two Ethernet ports on the gateway.
- Connect the WAN port of the gateway to a live Ethernet port before connecting any client device, or skip this if you use cellular data for network connection;
- Plug one end of the Ethernet cable into the LAN port on the gateway;
- Plug the other end of the Ethernet cable into the open port on a client device.
POWER SUPPLY
- Connect the terminal connector of the power cable to the terminal block of the gateway, and the other end to the power adapter;
- Plug the adapter into a 9 36V DC power outlet;
- The power indicator will turn solid green upon power application.
WARNING
Do not install the product on top of any other electrical equipment or place any other equipment on top the product.
Keep the product away from any heat sources such as direct sunlight, heaters, radiators, or other A/V receivers or devices that emit heat.
Failure or improper selection or improper use of the product described herein or other related items may cause death, personal injury or property damage. 
Vantron Technology, Inc.
Address: 48434 Milmont Drive, Fremont, CA 94538
Tel: 650-422-3128
Email: sales@vantrontech.com
G202
Quick Installation Guide
www.vantrontech.com
Documents / Resources
 |
Vantron G202 Industrial Edge Computing Gateway [pdf] Installation Guide G202 Industrial Edge Computing Gateway, G202, Industrial Edge Computing Gateway, Edge Computing Gateway, Computing Gateway, Gateway |
