Spark and Bell IP20 Rian Fluted Table Lamp
IMPORTANT
Please read the following instructions and warnings before using your new lamp. Retain for future reference.
WARNING
- Ensure lamp is fully assembled before connecting to power.
- Do not exceed bulb wattage on the label.
- Only use bulb type as specified on the label.
- For indoor use only.
- Not suitable for use in a bathroom.
Included:
- Table lamp with inline switch and plug
- Shade
Required:
- No special equipment
USER INSTRUCTIONS
- Unpack your table lamp and shade, and install shade:
- Lamps with Opal Globe Shades: After inserting appropriate bulb, fit the glass shade by screwing onto the lamp base. To ensure easy replacement of bulbs and the longevity of your light, please avoid over tightening.
- “Rian” Lamp: Place shade into groove in lamp base fully. Insert appropriate bulb.
- Plug your lamp into a socket and switch on.
- Operate the inline switch to turn on and off.
CARE INSTRUCTIONS
- Switch off, unplug from the wall and allow to cool before replacing the bulb.
- Clean using a soft dry cloth only.
- If the lamp will not turn on, please replace the bulb, and/or check and replace the fuse in the plug in the first instance. Please contact us in the event this does not solve the issue.
Contact Us
sparkandbell.com
01273 230566
contact@sparkandbell.com
Instagram: @sparkandbell
Spark & Bell, Ground Floor, Victoria House, Vale Road, Portslade, BN41 1GG.
Documents / Resources
 |
Spark and Bell IP20 Rian Fluted Table Lamp [pdf] Instruction Manual IP20 Rian Fluted Table Lamp, IP20, Rian Fluted Table Lamp, Fluted Table Lamp, Table Lamp, Lamp |