Bluetooth Remote Control
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This equipment must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and consider removing the no-collocation statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Hereby, Chongqing GATS Technology Co.,Ltd. declares that the radio equipment type is in compliance with Directive 2014/53/EU as well as UK Radio Equipment Requlations S1 2017 No.1206.
The full text of the EU/UK declaration of conformity is available at the following internet address: www.gatsteck.com/support for CE and UK.
OPERATING FREQUENCY(the maximum transmitted power)
BT LE 2402-2480 MHz(-11.99 dBm)
Documents / Resources
 |
gats RM180 Bluetooth Remote Control [pdf] Instructions RM180, RM180 Bluetooth Remote Control, Bluetooth Remote Control, Remote Control, Control |