EPIC OFFICE Boost Static Return Fixed Height Workstation Frame
OVERVIEW
Component parts
| NO. | Component Name | PCS |
|---|---|---|
| 1 | Bolt: M6x16 | 5 |
| 2 | Leveling pads | 2 |
| 3 | Table feet | 1 |
| 4 | Column | 1 |
| 5 | Bolt: M6x12 | 4 |
| 6 | Screw: ST4x20 | 13 |
| 7 | Side brackets | 1 |
| 8 | Rubber pad | 10 |
| 9 | Top frame-1 | 1 |
| 10 | Bolt: M6x10 | 3 |
| 11 | Centre bracket | 1 |
| 12 | Center rails | 2 |
| 13 | Top frame-2 | 1 |
| 14 | Hand bolts M6x10 | 2 |
| 15 | Allen Wrench(4mm) | 1 |
| 16 | Cable tie | 2 |
Assembly Instructions
Step 1
Loosen the pre-installed bolts and Adjust the length of the top frame to match the size of the tabletop.
Step 2
Inset the column to the top frame.
- First fix 2pcs screws M6x12 like C displayed
- And then tighten the pre-installed bolts like B displayed
Step 3
Install the table feet Screws 4 pcs M6x16,install the 4 leveling pads.
Step 4
Install the side bracket with Screws 2 pcs M6x12,
Step 5
Connect the return frame to the single workstation and fixed with 2 hand bolts. Fix the centre brackets with 2pcs screws M6x10.
Step 6
Mount the tabletop and fix it with 24 pcs screws ST4x20 Tighten the bolts on top frame to fix it.
Documents / Resources
 |
EPIC OFFICE Boost Static Return Fixed Height Workstation Frame [pdf] Instruction Manual Boost Static Return Fixed Height Workstation Frame, Boost Static, Return Fixed Height Workstation Frame, Height Workstation Frame, Workstation Frame |
