215U-2
INSTALLATION GUIDE
STATUTORY REQUIRMENTS
The 215U-2 is suitable for use in hazardous locations that are rated Class | Division 2, Groups A, B, C, D.
The 215U-2 must be installed in an enclosure that maintains an ingress protection rating of IP54 and meets the enclosure requirements of EN50014 or EN60079-0.
The RF coaxial cable must be installed in a metallic conduit, per the US National Electrical Code (NEC) or NFPA.
SUP+ and SUP- terminals must only be powered from an NEC Class 2 circuit.
WARNING – EXPLOSION HAZARD
Do not disconnect equipment while the circuit is live unless the area is known to be free of ignitable concentrations.
Substitution of any component may impair suitability for Class 1 Division 2.
NOTE
The 215U-2 modaule ships from the factory configured for global frequency and power. Set the radio region to access country specific radio options.
Models
215U-2-BGN — 2.4Chz Wikl band
Antenna installation
When selecting an antenna, consider radio proximity.
Use Figure 1 as a guide for installing an antenna and attaching it to the 215U-2.
Connecting to the module for configuration
- Download and install configuration utility software, available from the Elpro Technolgies website. www.elprotech.com
- Connect to PC using supplied USB cable.
- Connect to the device by selecting USB connection and using the IP address 192.168.111.1 or 1.1.1.1 for older firmware (pre V2.28)
- The PC will automatically be assigned an IP address from the module via DHCP. A new network adaptor will be created using IP address 192.168.1.2 (or 1.1.1.2)
- Username: user
- Password: user
The following illistrations show the port connections on the 215U-2.
Power Supply Wiring
The ground (GND) and “SUP -” terminals are connected internally to the ground (Earth) terminal.
Connect the screw terminal on the end plate to ground (Earth) for surge protection.
Expansion I/O Power and RS485 serial connection
An on-board RS-485 terminating resistor provides line termination for long runs.
Only enable terminating resistor on the last device connected on the RS-485 cable.
INSTALL GUIDE
Configuration Switches
Use the DIP switches in the side access panel to select analog input voltage or current, and to enable default configuration
| DIP | Description | OFF |
ON |
| 1 | Al3 Current / Voltage | Voltage | Current |
| 2 | Al3 Current / Voltage | Voltage | Current |
| 3 | Al4 Current / Voltage | Voltage | Current |
| 4 | Al4 Current / Voltage | Voltage | Current |
| 5 | Unused | Off | On |
| 6 | Default configuration | Normal | Enabled |
Input and Output connections
The digital input/output channels can be wired as inputs or outputs.
CONTACT
Australia
ELPRO Technologies
29 Lathe Street Virginia QLD 4014
T+617 3352 8600
E sales@elprotech.com
W elprotech.com
USA
ELPRO Technologies inc 2028 East Ben White Boulevard
#240-5656 Austin, TX 78741-6931
T +1 855 443 5776
E sales@elprotech.com
W elprotech.com
HOW TO ORDER
Simply send us an email at sales@elprotech.com, contact your local distributor, or phone +61 7 3352 8600
An envirada group company
Documents / Resources
 |
ELPRO 215U-2 Gateway With MQTT Sparkplug [pdf] Installation Guide 215U-2 Gateway With MQTT Sparkplug, 215U-2, Gateway With MQTT Sparkplug, MQTT Sparkplug |