Danfoss BasicRail Wall Heating in Wet Systems
Product Information
Specifications
- Product: BasicRail Wall Heating System
- Manufacturer: Danfoss Heating Solutions
- Model: VIGHA202
Installation Guide
BasicRail Wall Heating in Wet Systems
Installation of BasicRail Wall Heating in Wet Systems
Step-by-Step Instructions
- Inspection of the Pipe Wall: Remove unevenness and create a flat surface. Fig. 1
- Laying the Rails: Start by laying the rails vertically with a spacing of maximum 1 meter. Fig. 2
- Attaching the Rails: Attach the rails in three places with hollow wall anchors or nailed dowels and screws. Fig. 3
- Inserting Composite Pipe: Push composite pipe into the rails from bottom to top, starting with the supply line below. Fig. 4
- Pipe Bend Length: Do not exceed the maximum pipe bend length of 20 cm.Fig. 5
- Drilling for Wall Dowels: Drill at least 8 holes for wall dowels (70 mm) per square meter and attach the bottom section of the dowel. Fig. 6
- Attaching Metal Grid: Attach wall heating metal grid from top to bottom, lightly tensioned with 10 cm overlap, using the dowel upper section. Fig. 7
- Pressure Testing: After setting up the wall heating system, a pressure test to at least 6 bar according to the test report is required. Fig. 8
- Applying Plaster: Spray on the plaster in a single 35 mm layer from the top to bottom according to the manufacturer’s instructions. Fig. 9
- Smoothing Plaster: The applied layer of plaster can be smoothed or matted as required. Fig. 10
Contact Information
Danfoss A/S Heating Solutions
- Haarupvaenget 11
- 8600 Silkeborg, Denmark
- Phone: +45 7488 8000
- Fax: +45 7488 8100
- Email: heating.solutions@danfoss.com
- Website: www.heating.danfoss.com
Disclaimer
Danfoss can accept no responsibility for possible errors in catalogues, brochures, and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
FAQ
- Q: What is the maximum pipe bend length allowed during installation?
A: The maximum pipe bend length allowed is 20 cm. - Q: What pressure should be maintained during the pressure test?
A: The pressure test should be conducted at a minimum of 6 bar as per the test report requirements.
Documents / Resources
 |
Danfoss BasicRail Wall Heating in Wet Systems [pdf] Installation Guide BasicRail Wall Heating in Wet Systems, BasicRail, Wall Heating in Wet Systems, Wet Systems, Systems |
