dahua logo

DEE1010B
Video Intercom Extension Module
User’s Manual
V1.0.2

Introduction

The video intercom (VDP) extension module offers connections between a video intercom outdoor station (VTO) and door unlock options, a door open button and connection to an RS485 BUS for access card swipe input. The module fits inside an 86-type gang box for a secure installation. The module has one channel for door sensor input, one channel for exit button input, one channel for alarm input, one channel for door lock output, with a choice of Normally Open or Normally Closed options.

1.1 Typical Networking Diagram

dahua DEE1010B Video Intercom Extension Module

Connections

dahua DEE1010B Video Intercom Extension Module - Connections
No.Component NameNote
1+12VPower
2GNDGND
3485AHost RS485A
4485BHost RS485B
5POWERPower indicator
6RUNOperation indicator
7UNLOCKUnlock indicator
8NCLock NO
9NOLock NC
10COMLock public end
11BUTTONLock unlock button
12BACKLock door feedback
13GNDGND
14485BCard reader RS485B
15485ACard reader RS485A

Interface Diagram

dahua DEE1010B Video Intercom Extension Module - Figure 3-2

FAQ

Door does not open door after a card swipe.

– 1 Report the issue to the management center. The issue may be due to
(a) Card authorization has expired.
(b) Card is not authorized to open the door.
(c) Access is not allowed during the time.
– 2:Door sensor is damaged.
– 3:Card reader has poor contact.
– 4:Door lock or device is damaged.

The device does not communicate with the management center.

– 1:Check the RS485 wire connection.

Door does not open when pressing the open button

– 1:Check the connection between the button and the device.

The lock remains unlocked after the door opens.

– 1:Check if the door is closed.
– 2:Check if door sensor is connected properly. If there is no door sensor, check with the management center.

Another issue is not listed here.

– 1:Contact technical support.

Appendix 1 Technical Specifications

ModelDEE1010B
Access Control 
Lock NO OutputYes
Lock NC OutputYes
Open ButtonYes
Door Status DetectionYes
Operating Mode 
InputCard Swipe (card reader and unlock button required)
Specifications 
Power Supply12 VDC, ±10%
Power ConsumptionStandby: 5 0.5 W Working: 5 1 W
Environmental-10° C to +60° C (14° F to +140° F) 10% to 90% Relative Humidity
Dimensions (L x W x H)58.0 mm x 51.0 mm x 24.50 mm (2.28 in. x 2.0 in. x 0.96 in.)
Net Weight0.56 kg (1.23 lb.)

Note:

  • This manual is for reference only. Slight differences may be found in the actual product.
  • All the designs and software are subject to change without prior written notice.
  • All trademarks and registered trademarks are the properties of their respective owners.
  • Please visit our website or contact your local service engineer for more information.

© 2021 Dahua Technology USA. All rights reserved. Design and specifications are subject to change without notice.

Documents / Resources

dahua DEE1010B Video Intercom Extension Module [pdf] User Manual
DEE1010B Video Intercom Extension Module, DEE1010B, Video Intercom Extension Module, Extension Module, Video Intercom Module, Module

References

Leave a comment

Your email address will not be published. Required fields are marked *