Audio-technica Modular Gooseneck Microphone XLR Power Module User Guide

Audio-technica Modular Gooseneck Microphone XLR Power Module User Guide

Thank you for purchasing this product. Before using the product, read through the user manual to ensure that you will use the product correctly. Please keep this manual for future reference.

Contents hide

1 Safety precautions

2 Cautions for the product

8 Documents / Resources

8.1 References

9 Related Posts

Safety precautions

Although this product was designed to be used safely, failing to use it correctly may result in an accident. To ensure safety, observe all warnings and cautions while using the product.

Cautions for the product

Do not subject the product to strong impact to avoid
Do not disassemble, modify or attempt to repair the

Do not handle the product with wet hands to avoid electric shock or
Do not store the product under direct sunlight, near heating devices or in a hot, humid or dusty

Notes on use

Do not swing or pull the product. Doing so may cause disconnection or
The circuitry in the microphone takes about 30 seconds to stabilize after power is You may hear some audio disturbance during startup.

Check that the case ground is grounded with the mic cable latch firmly engaged before
Do not excessively bend the gooseneck assembly, rotate the ends of the capsule, or pull on them. Doing so may cause disconnection or

The product is a modular system comprised of a microphone element, gooseneck assembly and power Make sure the parts are firmly attached before use.
Do not remove the rubber O-ring on the power module connecting part at the lower section of the gooseneck assembly and the lower part of the XLR power

When attaching parts, remove the black cap on the capsule connecting part of the gooseneck Do not remove the silicone part at the end of the capsule connecting part.

① Microphone Capsule	C	ESE-Ca: Cardioid microphone capsule AT8109a
	H	ESE-Ha: Hypercardioid microphone capsule AT8109a
	ML	ESE-MLa: Line + Gradient microphone capsule AT8138a
② Gooseneck Assembly	6	ES925/6
	12	ES925/12
	15	ES925/15
	18	ES925/18
	21	ES925/21
	24	ES925/24
③ Power Module & Accessories	Included	ES8544 Set screw , M2 x 2 mm , (2 pcs) Hex wrench , 0.89 mm XLR Power Module (3-pin)
③ Power Module & Accessories	Optional	AT8473 AT8474 5/8”-27 to Quick-mount Universal 3/8”-16 stand adapter isolation mount threaded adapter

Assembly

Insert the gooseneck assembly (c) while rotating it into the XLR power module (d), and tighten it firmly. Check that the gooseneck assembly does not rotate, and use the included hex wrench (f) to tighten the set screw (e). Connect the capsule (b) to the gooseneck assembly, and attach the windscreen (a). If the parts are not sufficiently tightened together, problems may occur such as the LED not lighting up to the set color or sound is not output.
If you are using the AT8474, make mounting reference holes (with a diameter of 1.5 mm (X) on the circumference of a circle with a diameter of 40 mm) in the mounting Make a hole with a diameter of 25.4 mm in the center (Y) of the mounting surface for the XLR power module. The outer diameter of the mounting surface is 52.4 mm (Z).