Installation Guide AWM-BT
Infinite Mounting Possibilities 
COMPONENT CHECKLIST
Desk
REQUIRED TOOLS
- Phillips Head Screwdriver
CAPACITY
Flat Monitor
4.5 – 25kg (10 – 55lb)
Curved Monitor
4.5 – 18kg (10 – 40lb)
Display Size
24” – 55” 300mm (12”) max overall display depth
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! Each Tilt Bracket supports a maximum weight as per above capacity specification.
! Avoid applying downward load to corners of display.
! This product is not suitable for outdoor use.
! Do not use this product for mobile applications.
! The manufacturer accepts no responsibility for incorrect installation.
! This product is compatible with Atdec AWM Series products.
! VESA mounted accessories (such as mini PC brackets and mounts), and offset VESA locations exert additional leverage that can exceed the capacity of the mount even though the monitor weight may be within the stated range. Please contactAtdec if you would like further information.
! WARNING! Death or serious injury may occur if a child climbs on or tips product.
Attach VESA plate to display
1.1 VESA compatibility
NOTE:
Some displays require the use of a VESA adapterbefore attaching the VESA plate. This VESA adapter may ship in the box with the display. Consult your display’s installation guide for further information.
Option A Attach VESA plate with M4x10mm screws.
Option B For recessed VESA use 10mm spacers and M4x20mm Screws.
Slide bracket onto post and set height
2.1 Tilt bracket must only be attached with display facing the front of the mounting surface unless fixing is Grommet Clamp (AC-GC).
2.2 Line up the inner guide n rear of bracket with rear channel on post.
VIEW FROM ABOVE
2.3 Slide inner guide into channel and lower bracket.
2.4 Firmly tighten hand knob at chosen height.
Attach display
3.1 Set VESA plate clips to open position.
WARNING: Use two people to install display
3.2 Lift display until VESA plate is above the heightof the bracket. 
3.3 With post centered slowly lower display until bar on VESA plate sits in saddle in bracket.
3.4 Set VESA plate clips to closed position.
NOTE:
Display hangs from the bracket like a painting. After clips are closed, if corners of the screen are pushed downwards, rocking movement is expected.
Set tilt
4.1 Adjust display tilt angle by gripping edges of screen and rolling up ordown to desired position.
OPTIONAL ADJUSTMENT – TILT FRICTION
4mm hex key can be used to reduce tilt friction (for light screen) or increase tilt friction (for heavy screen).
4.2 Tighten tilt knobs to set.
Fine adjustment
5.1 To correct horizontal angle of display +/- 3°: Turn a single fine adjustment knob to adjust angle of display.
5.2 To close small gap between displays +/-6mm (1/4”):
Turn both fine adjustment knobs – alternating sides a few rotations at a time.
Clockwise = Higher
Anti-clockwise = Lower
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. ©20230120
Please recycle 
Documents / Resources
 |
ATDEC AWM-BT Mounting Bracket for Monitor [pdf] Installation Guide AWM-BT Mounting Bracket for Monitor, AWM-BT, Mounting Bracket for Monitor, Bracket for Monitor |
