ANALOG DEVICE - Logo

POWER SOLUTIONS FOR PRECISION TECHNOLOGY SIGNAL CHAINS
PRECISION NARROW BANDWIDTH
Fully Integrated Voltage and Current Measurement
Density and Latency Optimized Sensor Ready
Rev. 0 | Jan. 2022

ANALOG DEVICE Precision Narrow Bandwidth Signal Chains - Cover

This document is interactive. You can click on any underlined text to navigate through the document.

APPENDIX

For the resources:

ANALOG DEVICE Precision Narrow Bandwidth Signal Chains - For the resources 1

ANALOG DEVICE Precision Narrow Bandwidth Signal Chains - For the resources 2

For the individual pages:

ANALOG DEVICE Precision Narrow Bandwidth Signal Chains - For the individual pages 1

Isolated Multichannel

ANALOG DEVICE Precision Narrow Bandwidth Signal Chains - Isolated Channel

PART # DESCRIPTION
LT3471 Dual 1.3A, 1.2MHz Boost/Inverter in 3mm × 3mm DFN
LT8604 High Efficiency 42V/120mA Synchronous Buck
LT8570 Boost/SEPIC/Inverting DC/DC Converter with 65V Switch, Soft-Start, and Sync.
LT8570-1 Boost/SEPIC/Inverting DC/DC Converter with 65V Switch, Soft-Start, and Sync.
LT3999 Low Noise, 1A, 1MHz Push-Pull DC/DC Driver with Duty Cycle Control
ADP7118 20V, 200mA, Low Noise, CMOS LDO Linear Regulator
ADP7142 40V, 200 mA, Low Noise, CMOS LDO Linear Regulator
ADP7182 –28V, −200mA, Low Noise, Linear Regulator

POWER REQUIREMENTS

PARAMETER STAGES Ref. Buffer Isolation DAC Amp Protection
Part ft LTC6655 ADA4077 ADuM1441 LTC2756 A08675 ADG5401F
Pin IN V+ V- VDO1 VOD2 VDD V+ V- VDD Vss
Supply Voltage V 5 15 -15 3. 3. 3. 15 -15 15 -15
Supply Current mA 2. 0.65 -1. 0.9 -1. 10 4. -4. 0.22 0.09
PSRR dB 40 (10kHz) 12 (1MHz) 24 (1MHz) 48
(1MHz)
52
(1MHz)
82 (1MHz)

Note 1: The supply currents indicated are the maximum quiescent current of the supply rails. For overall full load or short circuit current specifications, refer to the datasheets of the signal chain components.
Note 2: The supply voltages indicated are the values for typical applications.
Note 3: Consult the corresponding datasheets for details on power dissipation if needed.
Note 4: The actual supply current requirement shall be multiplied depending on the number of channels on the signal chain.

©2022 Analog Devices, Inc. All rights reserved.
Trademarks and registered trademarks are the property of their respective owners.

Documents / Resources

ANALOG DEVICE Precision Narrow Bandwidth Signal Chain Platforms [pdf] User Guide
Precision Narrow Bandwidth Signal Chain Platforms, Narrow Bandwidth, Signal Chain Platforms, Chain Platforms, Bandwidth

References

Leave a comment

Your email address will not be published. Required fields are marked *