LAUNCH X431 Creader TPMS 5011 V2 Tire Pressure Sensor Scanner
Components & Controls
Powering Up
The tool can receive power via either of the following ways:
Method 1: Via Data Cable
Connect one end of the included data cable to the charging port of the tool, and the other end to the PC.
Method 2: Via Diagnostic Cable
Connect the diagnostic cable of the tool to the vehicle’s DLC (Data Link Connector) port.
*Note: The DLC is usually located 12 inches from the center of the instrument panel (dash), under or around the driver’s side for most vehicles. See diagram for possible DLC location.
Getting Started
The first time you use this tool, you will need to make some system settings and keep the diagnostic software updated with the latest version.
Follow the steps below to proceed.
Now the tool is ready for use.
If you have any questions on the operation of the tool, please contact customer service.
All information in this material are based on the latest information available at the time of printing. We reserve the right to make changes at any time without prior notice.
For more detailed operations, please refer to the In-app User Manual (“Data” -> “Product Manual”).
Documents / Resources
 |
LAUNCH X431 Creader TPMS 5011 V2 Tire Pressure Sensor Scanner [pdf] User Guide CRT511S V2.0, X431 Creader TPMS 5011 V2 Tire Pressure Sensor Scanner, X431, Creader TPMS 5011 V2 Tire Pressure Sensor Scanner, TPMS 5011 V2 Tire Pressure Sensor Scanner, Tire Pressure Sensor Scanner, Pressure Sensor Scanner, Sensor Scanner, Scanner |