LaserPecker Bluetooth Dongle Firmware Upgrade Instructions
LaserPecker Bluetooth Dongle Firmware Upgrade

* Please make sure your LP machines is powered off in case the app is connected to the machine instead of the dongle.

Steps:

  1. Plug your LP Bluetooth dongle into a computer to power it on.
  2. Scan the QR code below to download the LP Firmware Upgrade APP. It’s clean app, sopleaseclick“ Continue Installation” to authorize its installation.
    QR Code
    Installation
  3. Open the app, and click Bluetooth Dongle Firmware Upgrade at the bottom(you Bluetooth dongle will be connected at the same time).
  4. The app will auto-detect the firmware version your LP Bluetooth dongle and recommend the newest available installation package. Choose the package and click Start upgrade.
    Installations
  5. Wait until the progress notification reaches “100” and the prompt says ”Succeed”.
    Installations

Now, you’ve successfully upgraded the firmware of your LaserPecker Bluetooth Dongle.

LaserPecker Logo

Documents / Resources

LaserPecker Bluetooth Dongle Firmware Upgrade [pdf] Instructions
Bluetooth Dongle Firmware Upgrade, Bluetooth Dongle, Dongle Firmware Upgrade, Dongle

References

Leave a comment

Your email address will not be published. Required fields are marked *