Flexi-Messlatte
User Guide
Flexi-Messlatte DERR Laser and Measurement Device
Principles of taking a measurement using the flexi levelling staff:
In the first step the laser measuring device is aligned and the laser receiver (A) is mounted onto the levelling staff and set to “0”. Next, the knurled screw (B) is used to set the flexi levelling staff exactly to laser beam height “0” (Picture 1).
The laser receiver is then re-adjusted and moved to the height of the laser beam (Picture 2).
If the measurement point lies below the starting level, the levelling staff will indicate a negative value; if it lies above, the value indicated will be positive. So, the plus/minus scale indicates the correct height reference value straightaway, without the user having to carry out any calculations.
C Plus/minus mm scale
D Height difference
E Millimetre scale for measuring heights
SERVICE
Umarex GmbH & Co. KG
– Laserliner –
Möhnestraße 149, 59755 Arnsberg, Germany
Tel.: +49 2932 638-300, Fax: +49 2932 638-333
info@laserliner.com
Umarex GmbH & Co. KG
Donnerfeld 2
59757 Arnsberg, Germany
Tel.: +49 2932 638-300, Fax: -333
www.laserliner.com
Documents / Resources
 |
Laserliner Flexi-Messlatte DERR Laser and Measurement Device [pdf] User Guide Flexi-Messlatte DERR Laser and Measurement Device, Flexi-Messlatte, DERR Laser and Measurement Device |
