TRAIL CAMERA
HC-804A 
USER MANUAL
Product Introduction
Some Tips Before Everything
- If you observe a red flash when you take photos, please turn the switch from “TEST” to “ON”.
- After you turn the switch from “TEST” to “ON”, you will observe a countdown from 15s to 1s, then the screen will shut down. This is completely normal. You can walk in front of the camera to check if it takes photos and videos.
- Do not dip the camera in the water.
- The camera can work under 160°F but please keep the camera far enough from fire to protect batteries.
- Alkaline batteries are recommended because alkaline batteries are able to provide strong and stable power fo the camera.
- Please do not mix old batteries and new batteries.
- If an DC 6V power adapter is used to supply the camera, please make sure there are no batteries in the camera in order to prevent the overcharge.
 |
 |
Parameter
| Photo Resolution | 36/24/16/12/8/5/3/1MP |
| Video Resolution | 2.7K/1080e/720P/480P/240P |
| Detection Angle | Up to 120° |
| Detection Distance | 80ft (day), aft (night) |
| Fill Light LED Wavelength | 940nm (No Glow) |
| Fill Light LED Quantity | 36 pcs |
| Trigger Time | 0.2s – 0.5s |
| Waterproof Level | IP66 |
| Working Temperature | -4°F – 160°F |
| Memory Cord Type | Up to 32G TF Card (Class 10) |
| Power Supply Type | Battery/External |
| Battery Type | AA Battery |
| Working Voltage | 6V |
| External Power Supply | DC 6V |
| Standby Time | Up to 6 Months |
| Photo Format | JPEG |
| Video Format | AVI |
| Screen Size | 2.0 Inches |
| Size | 135x 90×76 MM |
| Weight | 0.38 kG |
Function
| Mode | You could choose the working mode | Photos (default) Videos Photos & Videos |
| Photo Resolution | You can choose different photo resolution | 24MP 36MP 16MP 12MP 8MP 5MP 3MP 1MP |
| Photo Series | You can set the photo quantity when the camera is activated | 1 photo (default) 2 photos in series 3 photos in series 10 photos in series |
| Video Resolution | You can choose different video resolution | 2704’1520P 1920’10809 1280’720P 848’480P 720°480P 640’480P 320’240P |
| Video length | You can choose the length of video | 3 seconds to 10 min. |
| Audio Recording | You can decide if you want the camera to record sounds | On (default) Off |
| Shot Lag | The time interval between each trigger | 5 seconds (default) to 60 minutes max. |
| Side Motion Sensors | You can turn On / Off Side Motion Sensors | On / Off |
| Sensitivity Motion Sensors | You can adjust the sensitivity of the motion detection sensor. | Low Middle (default) High |
| Target Recording Timely | You can set the camera to record between a certain period record | On (to set the period) (default) |
| Time Lapse | Set up time lapse mode and the length of the lapse. | On / Off (default) |
| Language | To set different language | English |
| Endless Capture | If Endless Capture mode is on. the camera won’t stop recording when the memory card is full but will delete the oldest videos or photos to keep recording continuously | On Off (default) |
| Time & Date | To set time and date. You can also choose the time format (24h or 1 2 h ) and choose the date format (dd/mm/yyyy, yyyy/mm/dd or mm/dd/yyyy) | Set Time & Date Time Format Date Format |
| Photo | To choose if there will be time | Time & Date |
| Stamp | and date on the photo. | (default) Date Off |
| Password Protection | Set up password to secure your camera | On Off (default) |
| Format Memory Card | Decision with caution! You will lose all of the data in the memory card if you decide to format it | Yes No (default) |
| Serial NO | To set up the serial number of the camera”} | On Off (default) |
| Reset Settings | Reset all the settings to the original settings | Yes No (default) |
| Version | Version of the system | 9135 |
- For example, wised the 1 minute video length and 30 seconds shot lag. When the camera detect an animal, it will start to record a 1-minute video. However, fee camera will not defect continuously. When the video is done, the camera will not detect immediately. It will detect again 30 seconds after the video in order to save the battery.
- In order to use the “Target Recording Time” function, please make sure that you have beady fume of the “Time Lapse” function and set up the length of the lapse between each photo.
- If you use several cameras aft the same fame and you want to recognize which camera food which photos and videos, set up a serial number could help you. The serial number will show on the bottom right of the photos or videos.
QA
1. I can't turn on my camera!
Please check if the batteries is full power; Please check if battery polarity is corect; Please re-install the batteries.
2. My camera is not taking photos or recording videos!
Check if the TF card is Class 10; Check if the TF card works normally on other devices; Format the TF card.
3. The camera doesn't detect anything!
Please make sure that the camera is not behind the glass; Please check the setting in the menu to adjust the detection distance and the detection sensibility of the camera then fry again.
4. Why the camera doesn't record during the night but it works well during day time!
Please check the battery level of the camera. If the battery s low (1/3 of the full battery), the night vision function will automatically shut down. Please change the batteries then the night vision function will restore.
Documents / Resources
 |
Lamgool B0CDQ5SRVG Trail Camera 1520P 36MP Mini Game Camera Hunting Camera [pdf] User Manual B0CDQ5SRVG Trail Camera 1520P 36MP Mini Game Camera Hunting Camera, B0CDQ5SRVG, Trail Camera 1520P 36MP Mini Game Camera Hunting Camera, Camera 1520P 36MP Mini Game Camera Hunting Camera, 36MP Mini Game Camera Hunting Camera, Game Camera Hunting Camera, Camera Hunting Camera, Hunting Camera |